help

So im wondering what amp I should get for a single pioneer pro series?Pioneer TS-W261D4 Champion Series 10" subwoofer with dual 4-ohm voice coils at Crutchfield.com

Here is my current setup (I know it's pretty ****, but I got it nearly free and as a teen you can't complain) Single Sub - Pioneer TSW261D4 10-Inch Champion/DUAL4 OHM/1200W/40 Equalizer Amp - Sony XM-N502 (Xplod 500 Watt) Here is the problem, ever since I blew the last subwoofer which was a...

Hello all! I went through a couple different set ups in my old Galant, but unfortunately the transmission died on me. I started with one 12" Kenwood then moved to two of the same subs, then three. Then I sold those and bought two 15" JBls. All of which were in sealed boxes and powered by...

I have 2 American Bass XFL 1544s ran to 1 ohm on a Hifonics Brutus 2k. Ive only had them about 2 months and they have just recently started to make a loud popping noise and a higher pitch hum. Sounds like a mechanical noise. I have my amp tuned right and gains set correctly. I was wondering what...

I have a power acoustik head unit 75wx 4,a Reaper model r4-1000 running 2 infinity kappa 5x7 in front doors,then i have a reaper model R1-4000d mono block amp running on 1 12inch mofo wired to 1 ohm.I have a lightning audio 4gauge wire kit that both amps are running off.The guy that installed it...

So my situation is I have a 96 camaro as my first car and I am looking to get a new stereo in it. I took it to a local audio shop to get an estimate on what it might cost me. The total he came to for the installation and everything would be about $685.00. What he included was a head unit, 2 sets...

Hello, so I am looking at buying the listed below for my 14 Mustang and am wondering how many feet of wiring I'll need (ball park), what gauge of wire, if I should get a dry cell and if so what should I look for, and any general comments or advice on any of the components. Any help is much...

Ok so I have a JL 1000/1 amp. Everything is hooked up correctly, double and triple checked it. Ok so here's the question. Should of any voltage be read at the +/- speaker terminals with the amp/ car shut off? Right now I'm reading .038v at the speaker terminals with the amp off (power light is...

Hi new here to the forum, so this is my first post I have an amp that I purchased in a lot of audio equipment a while ago. But I've never known the brand, model or actual rating of the amp. I once found the amp online but lost it. I'm hoping someone has one of the same amps or has some...

I have a 2006 chevy 1500 extended cab, I have raised the back seat 3" to fit my alpine type r 12"s. box is build but i am searching for some help on how to port it properly. the amp i am running is an alpine MRP-M2000. the main area of each side of the box measures 20"x16"x13"on the tall side...

So, I've never really had anything worth mentioning in the trunk/cargo area of any vehicle that I've owned. With that being said, I've got some cash to spend and I want to do this right. I have a '99 Tahoe and all of the speakers inside have been replaced with Fosgate components. Now I need the...

I have a 2006 chevy 1500 extended cab, I have raised the back seat 3" to fit my alpine type r 12"s. box is build but i am searching for some help on how to port it properly. the amp i am running is an alpine MRP-M2000. the main area of each side of the box measures 20"x16"x13"on the tall side...

i just sold 2 soundqubed hds315 dvc 2ohm woofers bc they needed more power than what i had them on and i do not want to spend any more money on my electrical system to handle more power, they were wired at 2ohms on a crescendo s1500.1 getting around 1000w (i know, way underpowered) in a 7cu...

I have some Skar Audio 6.5 components in the front and rear doors. I have them hooked up too the crossovers through a Rockford Fosgate 300.4 amp and on the certificate it came with it says it pushes 404w RMS. I have knukonceptz 4 gauge going back too it and a XS Power big 3 kit under the hood...

Hey guys, happy holidays! I know close to ZERO about car tech or audio tech. I would not describe myself as an audiophile by any means but I do know that when I listen to music I like listening to good quality sound whether it be in my car or anywhere. In February of 2014 I decided I wanted to...

How's it going everyone? For starters I would like to point out that I am a complete noob when it comes to car audio. I haven't gotten a real chance to hear many higher end speakers, let alone be able to hear all of the different brands that I've heard about researching online. As of right now...

SORRY FOR THE WALL OF TEXT. I finally did it! I found a way to shove my Skar ZVX-18 into my incredibly shallow mustang trunk. Unfortunately, there is this terrible rubbing sound(and its loud!) coming from it at high volumes on LOW notes. Now i suspect its one of two things and i'm looking for...

Im really wanting to get a loud setup and get something to scare people. Im sure thats a goal we all have in common, Lol. But right now my current setup is 2 JL W0v3 12's in a bandpass box, Hifonics BRX2000.1d, 0 G wire, Big 3, Kinetik 1k, and JVC xd320bts head unit. It sounds decent right now...

I have the r2000 boss 2000watt monoblock amp which puts out 750W RMS @4ohms,my subwoofer is the terminator 2 12" subwoofers 200W RMS each@2ohm..should i make them4ohm and how?please help if needed email me adrianxboxaaa2@gmail

I have the r2000 boss 2000watt monoblock amp which puts out 750W RMS @4ohms,my subwoofer is the terminator 2 12" subwoofers 200W RMS each@2ohm..should i make them4ohm and how?please help if needed email me adrianxboxaaa2@yahoo

Setup in signature: DC 3.5K, 2 12" Ethos, wired at 1 ohm (Used the12volt.com and I checked like 3x). Put my dmm/clamp (Fluke 323) on ac volts into speaker terminals on amp. Highest I saw was ~55. Put clamp on + speaker wire (right next to amp). Highest was 14.6 Am I really rising to about...

Hey this is my first forum post, so don't hate on me too much. But I have done a lot of research and are familiar with the basics of car audio. But I'm also very open-minded to any helpful ideas or constructed criticism. I have a 2010 Ford Fusion SEL with Sony Audio System, so for right now I...

Im looking to spend around $800 on a setup, Ive been looking at the Hifonics Brutus 2416.1D and an American Bass XFL1522. My alternator is stock, I have a huge trunk( Enough for 2 12s, or 1 15). My current setup is 2 JL Wv3 12's and a Sony Xplod 1000w XM ZR1852. What would be the best way to...

I don't know whether or not I messed up with something or if I have to do something specific, but i'm just going to ask you guys. I didn't want to say it because of how embarrassing it is but I did kinda order my box a little big, but in the wrong way. My box sits about 11 inches away from the...

I want to run 2 American Bass XFL 15" (1000W RMX Each) and 2 JL WOV3 12"s (300W RMS Each) in my 2001 Chrysler 300M. I cannot find an aftermarket HO alternator for it and im pretty sure im going to need it. Right now this is the list i have came up with for the setup i want to build . 2 American...

I have an enclosure built by CSCStang (amazing btw). It looks kinda like this: Info: 38x16x20 5.67 gross volume 3.8 net (1.9 per sub) 54.3 square inches of port. 13.77 per cube. Tuned to 32hz Question: How can I mount/un-mount the subwoofers (65lb DSS Ethos 12") without taking out the 200...

OLD Vehicle = 2007 Ford Edge Pioneer Avic 920bt Rockford Fosgate p850.4 (with a generously powerful birth certificate) Rockford Fosgate T252-s T2 in front doors Kicker KS or CS 6x8 in rear doors Dynamat installed on all 4 doors Rockfors Fosgate P3D2 12 inch sub in either 1 or 1.25 ft3...

im really new to car audio and im just not sure what kind of amp i should get. I have a soundquebed hdc15 d2 and am looking to spend around $200 to $250. The sub pushes around 1200rms so im looking for something that can put out close to that. Any suggestions?

im very new to car audio, this is my first setup and i have a few questions. i have a soundquebed hds315 D2 woofer (1200watt RMS) SoundQubed HDS315 And im getting a Kicker Cx1200.1 Amp Kicker CX1200 1 Car Stereo CX Class D Mono 2400 Watt Subwoofer Amp Sub Amplifier | eBay My question is...

Hey guys I got a few questions need some experts. I just got a zv4 15 d1 and can only wire to 2 ohm or .5 ohm. So I need help with my box and amp. I can ony wire to 2 ohm or .5 ohm. I have a few questions that need answering please! First the AMPS: Looking at the american bass vfl line...

this is the first audio system i am installing and i have absolutely no idea what to buy and install. I want something rich in bass and have those lights that pulse with the bass. Can anyone tell me what to buy and link to it?

So right now I am running two Kicker comp R's at 600w each at 4ohms on a Kicker cx1200.1 amp. I'm looking for some more bass with the amp that I have so once I find someone to buy these Comp R then i was looking into getting one 12inch x series sundown D2 which can handle 1250 watts. Will this...

Hi, I was hoping to get some thoughts/ideas/comments on the system I am planning on getting. So any help is appreciated, thnx for ANY help Music I like- Metallica and Top 40 Car- 2008 Nissan Frontier Crew Cab Head Unit- Sony WX-GT90BT Amp- Clarion XC1410 , 50 watts RMS x 4 at 4 ohms (75...

Well, I'm just you're average 17 year old honestly. I got my license about a month ago, and I drive a '99 Chevrolet Camaro Coupe Base model. When we got it, we noticed that the door speakers and the really mediocre quality Tweeters did not play. Eventually, while looking under the hood, we...

im looking into buying a 15" car sub. Im looking more for SPL but a side dish of SQ i wouldnt mind. For the sub my budget is around 150$. want to help me out??

Hey guys, I have a Cerwin-Vega V122D and it has some nifty little feature that I need help with. This subwoofer is a DVC and is 2ohms. It has only one set of terminals on it. Here is the sub Now, this sub has one set of terminals, and a switch that lets you go from 1ohm to 4ohm. How would I wire...

If any of you have some time to help me out with a few questions I'd appreciate it. TL;DR OP needs help   -->best way to get signal from stock head unit to amp -->which set of subs should I get and why -->what amp(s) should I get and why -->which highs/mids (woofers) should I...

Hello, in my 2007 Ford Fusion there are not rear 6x9 speakers currently. The only speakers are the factory door speakers. I'm looking to put in rear deck speakers myself and was wondering the best way to go about doing so? Please Help!!!

Hey guys I drive an 02 mustang that came with the mach 460 audio package, and its time to make some replacements. I hae a couple different topics I would like to know more about/get help with, but first a quick overview of the mach 460 system for those of you who don't know. The mach 460 and...

I would like to buy a batt or power cell im pullin 120 volts just somthn small??