Driver side should meter best, if you don't care about competing I don't think you'd notice the difference sitting in it.Still have not decided on driver side port or center port like I normally do.
Driver side should meter best, if you don't care about competing I don't think you'd notice the difference sitting in it.
Dammned.. How are your rear shocks holding up so far? I bet she sitting a little low by now. Subs in she deff be sitting low manFirst layer of roof done. Two pieces. Second layer will be one piece.
View attachment 52598
View attachment 52599
Alright so my internal specs are
41" wide
26" tall in front
27" deep.
Port is going to have to be at the middle/top.
An 8"x28" x 23" long port would be 224" but also tuned at 35hz. That would also be 5" from the back wall sitting flush in the 1.5" thick baffle.
Can't seem to get anything that is going to work that's tuned around 32 and that works with my dimensions....
What about in the middle just above the front seats? In between the seats?Alright so my internal specs are
41" wide
26" tall in front
27" deep.
Port is going to have to be at the middle/top.
An 8"x28" x 23" long port would be 224" but also tuned at 35hz. That would also be 5" from the back wall sitting flush in the 1.5" thick baffle.
Can't seem to get anything that is going to work that's tuned around 32 and that works with my dimensions....
Would that give you room on both side to place each sub/subs? And get it tuned lower?/?What about in the middle just above the front seats? In between the seats?
It's on coil overs so I can adjust them if I need to.Dammned.. How are your rear shocks holding up so far? I bet she sitting a little low by now. Subs in she deff be sitting low man
What about in the middle just above the front seats? In between the seats?
It's on coil overs so I can adjust them if I need to.
That's the problem. 44" wide total with two 18s doesn't leave much room in the middle.
I'm cutting the front baffle now so I can see in person what I am working with. Hopefully I can come up with something. It's either going to be tuned higher than I want or less port area than I should have unfortunately. We will see but I am pretty disappointed right now.
6x34" x 22.8" long tunes to 33hz and 204" of port. Which I can make work. BUT I'm assuming WinISD is meaning INTERNAL size of port. So adding in for wood 3/4" each side and I don't think I can fit it.
View attachment 52616
What about 2- 3" Aero-Ports?Or?3-2.50? or couple 4" ? Im not a box builder or? Just throwing it out there man