I just picked up some Infinity Kappa 60.9cs and some Infinity Kappa 63.9i. I am trying to decide on a 4 channel amp. The 60.9cs are 90 rms per speaker and the 63.9 are 75 rms per speaker. Looked at some hifonics amps but need some help on how much power i will need. New to car audio just...
Probably purchasing 2 Hifonics Brutus Brz12D4 in a couple weeks as it looks the best bang for my buck and I'm looking at how I should power them (amp). Looking at the Hifonics Brutus BRZ1200.1D and it puts out 1200w at 1 ohm should I just run them to the true rms (600w for 1)? Or should I look...
Hey i have a kicker solo x 18'' and i was wondering out of these two amps would be best to power it. Orion D5000 or the Hifonics Bxi2608d?
I know the orion is a good brand and same for hifonics so all advice is appreciated
Im about to buy a HIFONICS BRUTUS BRZ1200.1D 1200W MONO D amp for my 2 Kicker cvr 12's. I was told that i should buy a spare battery to run the amp. What size shuriken battery will be good for this setup?
i was wondering what the following parameters are for the BRZ15D4. i have two of them wired in parallel (if that makes a difference). i need the folowing parameters for the subwoofer.
Qts
vas
Fs
Re
Le
Xmax
Z
Qms
Qes
SPL
Pe
BL
Dia
SD
thanks a lot
Heres My Hifonics XX-Zuess 1600watt Amp
Started Smoking, I took it apart, Here's the problem (pix below).
Is it worth fixing? Is it costly? Or is it totally fried.
I do have a newer one on the way, I just want to know if i should salvage this or not.
I've been researching and I think I am going to buy a 12" Fi SSD subwoofer. I was wondering if you experts could pick me out an amp that would work well with the sub. Thanks!
well i found this shop selling a BRE1600.1D for 229$ now idk if its a good price?or if i should get it? plus what is the difference between the elite or the regular brutus? please and thank u for ur help
So, i have a RE Audio SXD418. Wired to 2 ohms. RMS on the sub is about 1000w. I just fried my RF 1000.1bd so now, looking for an amp that can push 1000 watts rms @ 2 ohms. Money is an issue right now, so preferably cheap. I was actually looking at the HIFONICS HFi1500D. Any other suggestions?
Item(s) for Sale:
(2) Hifonics hifi2500d
Item(s) Description/Condition:
They are used, not abused, bass knobs not included
HFi Series Single Channel Class D Car Amplifier
RMS Power Rating:
4 ohms: 850 watts x 1 chan.
2 ohms: 1700 watts x 1 chan.
1 ohms: 2500 watts x 1 chan.
Max power...
hey i am building a system for my mkz and picked out two xcon 12's i now need a amp(s) to power them im not trying to spend over 400 for the amps i was looking into hifonics, audiopipe and spl. the subs run on 1750w rms each the SSA tech told me i can run them at 2000w rms each so im looking for...
I have this hifonics brz1200.1 for trade. its a very clean amp but i just got an L7 and just want to settle down with a nice kicker zx750.1 and be done lol.
really want a kicker zx750.1!!! so pm me any offers.
So i have a Hifonics Brutus amp BXI2006D
its a mono amp and at 2ohm pushes 1300watts
(since its mono it splits 1300 evenly into two subs right? so 650watts each?)
but it has two (-) and two (+) slots like a 2channel amp
i also have 2 12" Alpine type Rs - 1800watts peak / 600 watts RMS 2ohms...
right now I have a FI Q 18 (sealed) that I am selling. I LOVE how low it gets and the volume is about as equal to my 2 cvrs ported. But i need more space in my car so I am going with smaller subs. I am between 3 square L5's.....2 12 audioque 2.5 or 2 12 re se. Need help!!!
I have a hifonics...
Item(s) for Sale:
Hifonics Brutus BRZ 1700.1D
Item(s) Description/Condition:
Perfectly Mint Condition.
10/10 functionally
10/10 cosmetically - Some paint missing where screws go. However when you screw it down, the new screws will cover this up.
Was used for about four months to power two...
i have just installed 4 hifonics hfi12d4 subs into my car, running them in pairs in series/parallel at 4 ohms per pair. they are in a sealed box with 2 chambers, 2 subs in each chamber. i am running them on a power acoustic 525w amp, bridged (until i get another amp) subs are brand new, when i...
I have been browsing subs for a long time now, and I decided on these because the quality is better than L7's [from what I've been told] and they hit almost as hard.
I'm still stuck on what amplifiers I'm going to have run this, I don't plan on spending more than 300 dollars on amplifiers...
I got about a week ago a hifonics amp hfi1500d mono and two kickers cvr aluminized (800 watts/ 400 rms).
The amp is mounted to the back the speaker box and the amp is at 3/4ths of its power.
What happens is when I turn on my truck the amp light is green and works but then goes red into...
hello good day i have a hifonics brutus amplifier bxi2008d which goes in protect as its switched on, apparently the audio driver board is damaged due to vibration
i would like to know where i can purchase the audio driver board please
model: SOB-002-09
i contacted hifonics but they do not...
so as of now i have a cadence dakota...2400 max, (supposedly 1200 rms) amp on my fi q 18 (dual 2 ohm)... basically it does nothing for the sub at all. and the amp will get hot as eff and then shut off. to even get the amp to do anything i have to crank the gain near all the way up and the bass...
So after a grip of searching and reading, I've narrowed my amp choices down to these three:
Audioque AQ1200D
Hifonics Brutus BRZ1200.1D
MB Quart ONX1.1500D
It will be powering an RE Audio SE Series SE12-D4 12" Dual 4ohm Sub (600 RMS / 1200 Peak), wired in parallel and in a sealed ~.9cu/ft...
Review of Subwoofer or Speaker:
2 hfi 12s in 3 cubes @35hz
they are on 300rms from a Audiopipe asm1300 @4 ohms and they are gettin loud .They are getting low as my previous 15s cvr(2)
they perform excellent solid clear bass im very pleased cant wait to put them on 600rms .. they are loud...
My fuse in the fuse holder keeps blowing everytime I hookup my power wire to battery. Never had this problem until I installed my capacitor and when I hooked it up. But that was when it was new and had no charge. Now that still has charge and its the only reason I can think of. Had a flat tire...
Item(s) for Sale:
LNIB hifonics bxi 2000
4 ohms: 650 watts x 1 chan.
2 ohms: 1300 watts x 1 chan.
1 ohm: 2000 watts x 1 chan.
True 2000 watts at 1ohm
Item(s) Description/Condition:
Iv had it hooked up for about a month. few signs of use. small scratch on the top
9/10 Physical
10/10...
Hey guys, so I'm back with another thread to try and get a little closure on products. So I've got the boxes made, filled with TC Sounds LMS-R 12's, ID Components in the front, Coaxial 6x9's in the back, proper electrical (HO Alt, Big 3, 2 Yellowtops), now its down to the amps. I was originally...
selling a Hifonics BXI1208D amp, my wife said it was too loud for her, so i took it out of her car. used for about a year, pretty much mint condition. this is a really mean amp. it's also a 25th anniversary edition amp. i still have the box and everything for it. also has a bass remote for it...
currently i have 3 12" cvr dual 4 ohm subs wired to a hifonics brutus 2000w amp at 2.6 ohms, it pushes them pretty hard with the gain turned up 2/3 of the way. i want to add 2 more subs to the setup dropping it to 1.6 ohms. looking for input on wether or not this amp will have sufficient power...
OK, I'm looking to upgrade speakers, get rid of the OLD Sony Xplodes and possible factory in-door. (I have Pioneer TS-A698's just sitting in the openings of the rear deck for improvement from the Xplodes that were there.) The biggest aggravation I've had so far in my own research has been a few...
For sale today are two hifonics class-d subwoofer amps - one is 1600 RMS at 1 ohm, the other is 2500 watts rms @ 1 ohm:
Hifonics Brutus BXI 2608D - 2600 RMS @ 1 ohm
I am the second owner of this amplifier. According to the previous owner, he only used it once, to test a sub. When I got the...
I'm selling my nearly new Fi audio Q 12" Dual 2 Ohm Sub. I bought it new from Fi audio last fall for $260. I used it for about 2 weeks and sold the truck. It's been sitting in my basement ever since. It has the brushed alloy dustcap decal. This sub is practically brand new. I'm asking $215...
First post here;)
I currently have 1 Hifonics Brutus BRZ1700.1D that puts out 1700WRMS @ 1Ohm @14.4Volts. It is CEA-2006 rated so it does the power and may be a bit more. I am planning on grabbing a second one, and was wondering if I bridge these together using an MLX-100, will it be able to...
Has anyone tried running a brutus at half an ohm daily? I have a BXi 1608D and was wondering if anyone has tested this out yet? I think thermal would be my biggest problem, if it doesn't go into protection, considering its around 90 degress here and the amp doesn't see much ventilation in the...
So I just finished installing my system in my new car and it isn't even a fraction of how loud it was in my old, which makes no sense to me because I upgraded from 8ga to 0ga power wire and from 14ga to 12ga speaker wire. The only things I've done differently in this car are grounded my amp to...
this car plays at 149.7 on the glass w? a term lab. ! kinetic 2400 runs this amp, box was designed with 7.6 Cubs with a 30 inch long port in the rear 3*33 sQ in opening, and originally for one SOLO x 18 but kicker cant get me a recone.