Amp setting help…

[Ridinhi 5,000+ posts]

This is my amp, Ct Sounds 2000.1
I am using the crossover in my h/u.
where should I set the Dials on the lpf and the frequency?
If I’m not mistaken, do I turn the lpf all the way to 180hz so it acts as “full pass”?

Click to read more...

 

[LFR]

the LP filter is cutoff for the frequencies. I run mine to 80ish normally some sub/box combos will sound good running it up a little more... if you want your head to do the work, you can run it up more and use the HU for xover point

 

[Bobbytwonames 5,000+ posts]

I run mine all the way open and run the crossover on my HU @ 70 hz. Frequency to the lowest and LPF all the way open.

 

[spokey9]

I run mine off the hu since it's got a much better crossover...my subsonic is set around 25hz and my lpf is wide open on the amp...off my hu the lpf is set to 80 with a 24db slope...my bass boost is off and my gain is a touch over half

 

[Ridinhi 5,000+ posts]

Cool, thanks guys. This is what I was thinking but wasn’t sure. I’ll go out and retune tomorrow in some daylight.