- Thread Starter
- #106
Update...
Installed amps to bat#2, installed sky high dual copper runs to sub amp (power/grounds) and bat#2, installed stinger volt meter... Had a ANL 150 fuse party (total of 5 new fuse holders, bat#1, before bat#2, after bat#2 (two runs) & mids amp) and took her for a spin...
14.3 was the steady number for about 25 min, mids never went into protect mode.
Then while still on the fwy, stinger meter dropped to 13.1 and stayed there for the remaining 10min drive (13.0 for a split second).
Is this normal?
Installed amps to bat#2, installed sky high dual copper runs to sub amp (power/grounds) and bat#2, installed stinger volt meter... Had a ANL 150 fuse party (total of 5 new fuse holders, bat#1, before bat#2, after bat#2 (two runs) & mids amp) and took her for a spin...
14.3 was the steady number for about 25 min, mids never went into protect mode.
Then while still on the fwy, stinger meter dropped to 13.1 and stayed there for the remaining 10min drive (13.0 for a split second).
Is this normal?