Need a 3d Visual and cutsheet please.

[sniper007 10+ year member]

yes magic u got the demensions right

 

[~Magick_Man~ 10+ year member]

give me a little while and i will have some kind of cut sheet for you.

~Magick_Man~

 

[sniper007 10+ year member]

ok sweet

 

[PV Audio 5,000+ posts]

7 //content.invisioncic.com/y282845/emoticons/crap.gif.7f4dd41e3e9b23fbd170a1ee6f65cecc.gif10 runs like crap on my computer for some reason.

but i do have it.

~Magick_Man~

It does need some resources to run properly //content.invisioncic.com/y282845/emoticons/frown.gif.a3531fa0534503350665a1e957861287.gif

 

[sniper007 10+ year member]

well i gotta jet right now ill be back in a hour or so, Thank you magic for helping me dude awesome job. Also dinty for taking time outta his day to explain a lot of things about my project.

 

[~Magick_Man~ 10+ year member]

i dont think i will have time to finish it right now.

i have to go to work.

so i will give you the two different angles the faces are on.

and you should be able to sit down with a piece of paper and figure out the pieces since you have the dimensions.

the faces that the subs mount on are on a 73° angle.

and the center console section is laid back on a 83.5° angle.

you should be able to get the cut list with that info.

but if not and nobody else has done it by the time i get off work i will finish it up for you.

~Magick_Man~

 

[sniper007 10+ year member]

ok thks magic

 

[sniper007 10+ year member]

bump no1 know how to get the cutsheet for my project?

 

[bluelceii 10+ year member]

Are you wanting to build in seperate chambers like this



or build it whole like this??



btw, I ask because you can make small cuts like in the 1st pic and just screw the boxes together.... or like the second pic, you'd have to cut larger pieces for the top bottom and back all the way across.

 

[sniper007 10+ year member]

the second 1 blue.

 

[bluelceii 10+ year member]

alright give me a lil bit I've got to run somewhere but I'll either work on that tonight or sometime tomorrow.

edit: will you be able to figure out the angle cuts on your own??

 

[sniper007 10+ year member]

blue, on the mid console i think u might have the demensions wrong cuz its depth is 5.5" by 7".

 

[bluelceii 10+ year member]

blue, on the mid console i think u might have the demensions wrong cuz its depth is 5.5" by 7".

according to what you put and the changes you gave me in the pm, this one lines up to what you said.

 

[sniper007 10+ year member]

yup thats it. just need cutsheet is all, not that important but would be nice.

 

[~Magick_Man~ 10+ year member]

cutsheet is done, finally

~Magick_Man~