Dsp crossover starting point

  • 3
    Participant count
  • Participants list

Jimg

CarAudio.com Regular
216
13
what is a good starting point for the dsp setting in a full active setup

subs. 10 inch. 80hz? Or would you go higher

door speaker. 6. 1/2. What range would you start with

door speakers. 5. 1/4. What range


dash tweeter. What range
 
80hz is a good starting point for your sub, assuming your midbass can get down that low. My starting point will be 80hz sub, 80-3500 hz for the bandpass and 3500hz high pass for the tweeter. That’s based on the frequency response for the speakers I am using. It’s obviously different for other types of equipment.
 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

Similar threads

I used Sancho as a distraction to get approval 😳
61
4K
Thanks for the input. Much appreciated. The dsp is an afterthought. I haven't installed anything yet but I put a budget system together. I already...
2
127
Easy fix, If your DSP has a single mono output, split it with a Y and run both to the sub. In my experience, even though the sub amp has two...
1
336
Okay, I'll bite. If you're going to get rear speakers, get the same ones (model type, doesn't have to be the same size) that you have up front...
1
716
DSP
I would wait until you get your system completed. The LC7i PRO has a built subsonic filter at 22hz and until you get the rest of what you will...
1
456

About this thread

Jimg

CarAudio.com Regular
Thread starter
Jimg
Joined
Location
Start date
Participants
Who Replied
Replies
2
Views
926
Last reply date
Last reply from
Louisiana_CRX
1000006564.jpg

Mr FaceCaser

    Mar 28, 2024
  • 0
  • 0
1000006569.jpg

Mr FaceCaser

    Mar 28, 2024
  • 0
  • 0

Latest topics

Top