Can't seem to hit lows even with the DD-1

But any who the real question is why did your dumb *** tune your box to 20hz? As I said earlier only bored and fooling around with tuning. ..Sorry OP for saying so much...Yall have fun

Sent from my SM-N910V using Tapatalk

 
Only frequencies above your setting come through so if I'm tuned at 20 hz and set my ssf @ 40 hz then nothing under 40 hz plays...
Sent from my SM-N910V using Tapatalk
it actually affects above 20hz a bit. Subsonic filter is basically a high pass filter that goes really low and with most filters, there's a slope. In general for amps its only a 12 db octave slope. It does not start at 20hz, it starts before and the rapid downward drop actually happens at 20hz but you'll start losing 1 or 2 db a couple of frequencies above. It'll look similar to this. Not as drastic drop as the graph but you'll definitely notice it.

40792d1362146078-few-questions-about-winisd-ixl15.jpg


 
d8adb087e973f0d316e300fa4b01ac7a.png



Sent from my iPhone using Tapatalk
I havnt read this thread at all but I had that box with some kenwoods in it. Hit a 136db on around 600rms but its tuned way high. Like almost 50hz and its absolutely stuffed with polyfill.

Not too terrible but plenty of room for sa and spl increase

Sent from my SGH-T999 using Tapatalk

 
Hey Camry, there was another member on here too with that very same sub enclosure. He couldn't figure out why he couldn't hit the low notes. I dunno if he ever fixed the problem but he said it was a gift to him.

How short is that port tube?

 
Hey Camry, there was another member on here too with that very same sub enclosure. He couldn't figure out why he couldn't hit the low notes. I dunno if he ever fixed the problem but he said it was a gift to him.
How short is that port tube?
i dont recall tbh. its been a few years. It stopped about half way into the first sub

.jpg


so somewhere between 7-11inches

 
I seen you were talking about my post with the kickers I did happen to find the original paper work with the measurements of the prefab box

Sent from my iPhone using Tapatalk

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

Similar threads

It's always leaned that direction. Not sure how cheap you can really get anything done these days. Deadening and custom mounting...
10
1K
We still need to know what amp is having the issue, make and model. Some mono amps only have 1 preamp input and the other is a output.
7
1K
I remember when the guy did the installation, he kept focusing on the loc, I remember him constantly talking about that and thats a piece he...
31
4K

About this thread

Kdruid

Junior Member
Thread starter
Kdruid
Joined
Location
Ormond beach, FL
Start date
Participants
Who Replied
Replies
88
Views
4,084
Last reply date
Last reply from
The Camry
445981256_3731324230470906_9081536917273579948_n.jpg

Decebal

    Jun 10, 2024
  • 0
  • 0
445387485_1610561083127261_6762343569694877677_n.jpg

Decebal

    Jun 10, 2024
  • 0
  • 0

New threads

Top