10" Sub Recommendation

I was leaning towards the IDQ as well but would only be able to feed it the 500 RMS when I can put out 1000 RMS from my amp at 2 ohm. Seems with such a small enclosure and sealed that more power going to it would be better. Am I thinking right?

 
you mentioned jlw3v3 in your initial post. i have one and they need 1.25 cubic feet sealed or so

at the top end of your budget of 300 and top end of your mounting depth 6.89 in

you can consider JL 10W6v3-D4

enclosure with only 0.55 cu. ft.

600rms 4ohm

Amazon.com: 10W6V2 10-Inch Subwoofer with Dual 4 Ohm Voice Coils: Electronics

JL on amazon is not covered with warranty i think, only 30 day returns

i got my jlw3v3 there and it turned out fine.

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

Similar threads

Getting a good voltage reading does not mean good power transfer. You could read 13.8v out of a 24 AWG wire. Recheck your amplifier's ground and...
2
204
That would be a function of the harness, not the HU, I think. Have you looked into a Maestro or iData interface? i would check with crutchfield...
12
542
thanks DB, that definitely helps swallowing a $300 price tag 😂 these would essentially be running midbass for me too
12
573
What is your budget? With being exposed to Rain.. I would recommend looking at a marine grade SAS Bazooka for the sub stage
3
672

About this thread

mitcheak

10+ year member
Junior Member
Thread starter
mitcheak
Joined
Location
Lakewood, CO
Start date
Participants
Who Replied
Replies
27
Views
3,378
Last reply date
Last reply from
seas88
20240604_170857.jpg

metalheadjoe

    Jun 5, 2024
  • 0
  • 0
Screenshot_20240605_200209_Adobe Acrobat.jpg

Dylan27

    Jun 5, 2024
  • 0
  • 0

New threads

Top