SSC6 Crossover *Quick Help*

[scotsman 10+ year member]

I noticed that the woofer in my driver door from this comp set wasn't working. I took off the crossover and found this. Is there anyway to fix this or do I need a new crossover? That wound up coil is hanging loose on 1 side, can I just glue it back together, I'm guessing i need to get it to sit in that little hole where it came out of and make a connection.

Click to read more...

 

[scotsman 10+ year member]

anyone?

 

[scotsman 10+ year member]

i want to fix these soon

 

[Latina33 10+ year member]

Hey man, not sure how to fix that, or if a fix will work, but I do have 1 used SSCS6 crossover that I could sell you if you end up not being able to fix that one.

Just throwing it out there for you, just in case.

 

[scotsman 10+ year member]

I saw that, I'll def pick it up if I cant fix this.

 

[scotsman 10+ year member]

doors want to go back on, someone help me

 

[headless 10+ year member]

You could try soldering it back down...should work if re-soldered, i would imagine.

 

[scotsman 10+ year member]

hmm it will be hard to solder in there

 

[headless 10+ year member]

Yep. Be careful not to melt the insulation on the wire too much... it's clear, but it's there! soldering iron, i would recommend 25 watt for that. needle tip. Can you not solder from the opposite/far side of the board?

 

[scotsman 10+ year member]

don't believe i can take the board off

 

[headless 10+ year member]

****, wtf.

 

[scotsman 10+ year member]

****, wtf.

it was glued in, but i took it off and soldered it from behind, now works like a champ. Thanks //content.invisioncic.com/y282845/emoticons/thumbsupwink.gif.129404938effda6ad9cca39e7f4b58a3.gif

 

[headless 10+ year member]

rock on - good job man. I was hoping it'd be screwed down - glue is pretty ghetto. Looks like you got the job done though. Good one m8.