jonerickson1
Junior Member
I have a
mrp-m1000 alpine amp, 1000w rms @ 2ohms.
Fosgate T1D410 4 ohm DVC wired @ 2 ohms 600w rms
I tried the 40 hz 0 db test tone and used the DMM to set it to 35 volts
It sounds ok but doesnt seem to be pushing the sub too hard.
when i play a regular song it only reads about 20 volts
I know the music signal isnt a sine wave but is that voltage still a representation of the power going to the sub?
How hard can i push it?
How do you do the distortion method?
Is that a good method?
Any other tips/ tricks would be nice. This is my first install.
mrp-m1000 alpine amp, 1000w rms @ 2ohms.
Fosgate T1D410 4 ohm DVC wired @ 2 ohms 600w rms
I tried the 40 hz 0 db test tone and used the DMM to set it to 35 volts
It sounds ok but doesnt seem to be pushing the sub too hard.
when i play a regular song it only reads about 20 volts
I know the music signal isnt a sine wave but is that voltage still a representation of the power going to the sub?
How hard can i push it?
How do you do the distortion method?
Is that a good method?
Any other tips/ tricks would be nice. This is my first install.