Menu
Forum
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Gallery
New media
New comments
Search media
Members
Registered members
Current visitors
Classifieds Member Feedback
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Register
Forum
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
Log in / Join
What’s new
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Menu
Reply to thread
Forum
Car Audio Help
Wiring, Electrical & Installation
Setting Gain
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="jonerickson1" data-source="post: 7037682" data-attributes="member: 626777"><p>I have a</p><p></p><p>mrp-m1000 alpine amp, 1000w rms @ 2ohms.</p><p></p><p>Fosgate T1D410 4 ohm DVC wired @ 2 ohms 600w rms</p><p></p><p>I tried the 40 hz 0 db test tone and used the DMM to set it to 35 volts</p><p></p><p>It sounds ok but doesnt seem to be pushing the sub too hard.</p><p></p><p>when i play a regular song it only reads about 20 volts</p><p></p><p>I know the music signal isnt a sine wave but is that voltage still a representation of the power going to the sub?</p><p></p><p>How hard can i push it?</p><p></p><p>How do you do the distortion method?</p><p></p><p>Is that a good method?</p><p></p><p>Any other tips/ tricks would be nice. This is my first install.</p></blockquote><p></p>
[QUOTE="jonerickson1, post: 7037682, member: 626777"] I have a mrp-m1000 alpine amp, 1000w rms @ 2ohms. Fosgate T1D410 4 ohm DVC wired @ 2 ohms 600w rms I tried the 40 hz 0 db test tone and used the DMM to set it to 35 volts It sounds ok but doesnt seem to be pushing the sub too hard. when i play a regular song it only reads about 20 volts I know the music signal isnt a sine wave but is that voltage still a representation of the power going to the sub? How hard can i push it? How do you do the distortion method? Is that a good method? Any other tips/ tricks would be nice. This is my first install. [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Help
Wiring, Electrical & Installation
Setting Gain
Top
Menu
What's new
Forum list
