BOOMINGRANDPA 5,000+ posts
WOLFRAM FTW
yeah they maybe 3 ohm u think that'll make most amps drop to 2 ohmNo, Infinity speakers are not 4 ohms but may be 2 or a bit more depending on the specific set.
yeah they maybe 3 ohm u think that'll make most amps drop to 2 ohmNo, Infinity speakers are not 4 ohms but may be 2 or a bit more depending on the specific set.
good ******* CALLAfter doing some reading, I raised my budget a bit and ended up going with a Zapco ST-4X SQ. Thanks for all your advice.
It's a cheap China amp. You can't have it all.yeah nice amp., shocked s/n is that low..
omg u back?, only seen your evil twin past week.. i told him check orion xtr 250 and 500.1 anyone know if they good cause price sure is right on those..It's a cheap China amp. You can't have it all. Quality is hit and miss also.
********It's a cheap China amp. You can't have it all. Quality is hit and miss also.
Ok. I'm not going to sit here and waste my time with you. It's a $150 amp. It's made in china. You win.BULLSHITyou don't know what your talking about they have great build quality.
a few people have posted internals and they look pristine and use higher end opamps.
No such thing as a wrong opinion buddy. //content.invisioncic.com/y282845/emoticons/laugh.gif.48439b2acf2cfca21620f01e7f77d1e4.gif
There's absolutely no point to argue with a post whore. I'm gonna be the bigger man here.
Calling linear power amps high end made your credibility fly out the window... sorry.
I've been called worst than that. Who's perfect? I see your point but lp amps are known gimmicks.you hypocrite. lol
Excuse my ignorance, but does this mean I should not bridge the amp to run my two Infiniti fronts? I think the specs on the Zapco state a value for bridged only on a 4 ohm load...yeah they maybe 3 ohm u think that'll make most amps drop to 2 ohm
yeah man we missed ohm load except trumpet, where u get it at ebay? be great if sell let u trade it.. we assume 4 ohm on speakers unless someone tells us, one of those 60x2 would worked., 3ohm bridged load (=1.5ohm stereo) is pushing your luck, the amp will at least run hot..Excuse my ignorance, but does this mean I should not bridge the amp to run my two Infiniti fronts? I think the specs on the Zapco state a value for bridged only on a 4 ohm load...
wow man u may be better off to actually pull one out and look at back see if it say 4 or 3 ohm on it, if 4 u can bridge it if 3 run in stereo u be fine and just don't use rear channels of amp and every 6 months u can swap wires on amp to other 2 channels lol 1/2 amp run 1/2 amp gets a break lol.. and later u may think about adding 2nd set of coax or something.. if they 3 ohm eventually u maybe better off going with 65 or 75x2 2 channel if u don't add speakers..I just looked it up, my fronts are Kappa 60.5cs. 3 sites online show them to be 4 ohm.