Falkor
Junior Member
Just bought the Orion HCCA D-2400 (mono) amplifier, and the speaker terminals are layed out for two speakers (without any 'bridge-mode' wiring diagram or anything).
which two terminals should i use?
the outer or inner terminals? (or, do i use ALL FOUR ?)
the manual doesn't state it directly, but shows the center two, yet images online show people using the outer ones, and the manual also states an internal bridge.... (does that mean any pos and any neg can be used?)..
or
- should all four terminals be used, and both pos go to the pos on the sub, and both neg terms go to the neg on the sub ?
also, i have a DVC 4ohm wired to run in parallel at 2ohms...
I'm still a little confused on this, and i don't want to only run half the power, and also don't want to ruin anything by over-wiring too.
any advise is appreciated... pictures would be doubly so.
thanks
ps, i found this thread here but it's closed and cannot ask my question
which two terminals should i use?
the outer or inner terminals? (or, do i use ALL FOUR ?)
the manual doesn't state it directly, but shows the center two, yet images online show people using the outer ones, and the manual also states an internal bridge.... (does that mean any pos and any neg can be used?)..
or
- should all four terminals be used, and both pos go to the pos on the sub, and both neg terms go to the neg on the sub ?
also, i have a DVC 4ohm wired to run in parallel at 2ohms...
I'm still a little confused on this, and i don't want to only run half the power, and also don't want to ruin anything by over-wiring too.
any advise is appreciated... pictures would be doubly so.
thanks
ps, i found this thread here but it's closed and cannot ask my question