Connorsully54
Junior Member
So I have a 400watt Kenwood amp and I have two 12 inch qpowers but only one will work if tried bridging I've tried going speaker straight to amp and I cant find out why only one will work...very frustrating
only one sub working!!!!!!!!
- Thread starter Connorsully54
- Start date
- Replies 1
- Views 373
Activity
No one is currently typing a reply...
Similar threads
Hmmm, if you are only switching the RCA's (imput to the amp) and the subs change which is putting out sound, that would be a bad RCA.
- Started by Shanowayno88
- Subwoofers 2
If you still have the old speakers, put them in and see what happens.
- Started by Badataudio
- Subwoofers
Everyone I found the problem it's the RCA cables, I had my electrician mate have a look and he pulled one of the cords halfway out and the subs...
- Started by Jahrome2301
- Wiring, Electrical & Installation
Ah, thanks for the advice, but you make that sound like that's a foregone conclusion. The crossovers I swapped out look and sound exactly the same...
- Started by Timboj
- Enclosure Design & Construction
Getting a good voltage reading does not mean good power transfer. You could read 13.8v out of a 24 AWG wire. Recheck your amplifier's ground and...
- Started by chris123
- General Car Audio
About this thread
New threads
-
Low volume ONLY while drivingI have a Skar svr-10 inch sub and a skar rp-800.1d 800w rms...
- Started by Maddoxp07
- Replies: 0
-
WANTED Down4Sound MM1004 GrayWould like a gray D4S MM1004 to match my other gray MM1004...
- Started by kenvicta
- Replies: 0
-
What's this worth?Going to go on a different direction when I get my new...- Started by chillin
- Replies: 4
-
-
Multi speakersHello all, need some wiring advise for some speakers. I have...- Started by 07FLSTC
- Replies: 2