Inter007 10+ year member
Senior VIP Member
- Thread Starter
- #16
so next i started test fitting back, and false floor before i permanently attached everything
Since everything seem to fit like wanted it too i stripped the seats off and what not so i could clean and be easier to set everything up.
Next I attached the 2x4 to back too seal off trunk and please 2 2x4 pieces to as to make sure false floor was level all across and not just the middle and put tons of PL glue to make sure it didnt go anywhere as well as brace hem to vehicle with bolts and washers.
After letting the 2x4 sit for long while i attached the the false floor to the 2x4s with glue and screws as well as glue the center part of the false floor to the groove directly to the car with a ton of PL glue as i could not screw or bolt it in due to gas tank. Also went ahead and cut out back piece and did a test fit to it
After a few days of letting glue sit i foamed any voids of floor
I reinforced the top back piece that would go above rear deck with some 2x4
Then attached rear piece
Since everything seem to fit like wanted it too i stripped the seats off and what not so i could clean and be easier to set everything up.
Next I attached the 2x4 to back too seal off trunk and please 2 2x4 pieces to as to make sure false floor was level all across and not just the middle and put tons of PL glue to make sure it didnt go anywhere as well as brace hem to vehicle with bolts and washers.
After letting the 2x4 sit for long while i attached the the false floor to the 2x4s with glue and screws as well as glue the center part of the false floor to the groove directly to the car with a ton of PL glue as i could not screw or bolt it in due to gas tank. Also went ahead and cut out back piece and did a test fit to it
After a few days of letting glue sit i foamed any voids of floor
I reinforced the top back piece that would go above rear deck with some 2x4
Then attached rear piece