ok, i have two audiobahn aw1051t 10" subwoofers...they're rated at 300 rms...and 600 ach...how big of an amp will i need to push these? w/o blowing them... they're dual 4 ohm voice coils... ummm, efficiency 91.0 db... what else you need to know to help me out, pleeeze... also, after choosing an amp, how should i wire them in their two seperate boxes?
Activity
No one is currently typing a reply...
Similar threads
Oh I get it, just put-n it out there!
It's all good man! ;)
No not in this situation.PM sent for proper use of the Y splitters for this situation
- Started by Mission Shane
- Wiring, Electrical & Installation 2 3
Sure, 600 volts, yep. If you’re trying to launch the subwoofer cones to the moon! And, that’s if they don’t just vaporize first!
- Started by barkbark
- Subwoofers 2 3
Only similar subs I could find are the BP-HP12d2. No 15s.
- Started by HelpMePlease1
- Subwoofers
When i would have 1st times in for bump, I would always set it to be safe in this case.... everything maxed out and not fry the subs. Enclosure...
- Started by Robertsteele1395
- Car Audio Build Logs
About this thread
New threads
-
No sound on new additionI have an Alpine Aix w650 Bluetooth headset with backup cam...- Started by Scott B.
- Replies: 0
-
Old School BuildI had to remove this old school build a couple of days ago...- Started by Bobbytwonames
- Replies: 0
-
Drilling through carpetWhen I install my amp rack in my Caddy I will need to drill...- Started by maylar
- Replies: 3
-
New audio setup has a BUZZI am relatively new to car audio and was originally quite...- Started by Corsair714
- Replies: 7
-
FEATURED Aftrmarket Android 10 with DSP build in (mazda 6 skyactiv 2017) interference problem AUX IN -NOT OUTPUT! (no whine noise or engine rpm)Hello all. At the beggining i would like to apologize for too...- Started by JustAguy39
- Replies: 0