Sidebar

Is there a rca distribution block to run multiple amps

Reply
  • 3
    Participant count
  • Participant list
Jump to latest
maxxlink is a bridging module isn't it? That doesn't have anything to do with your question.

You can either use the rca outputs from the amp - if it has them, or just use y cables.

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.
Previous thread Next thread

Similar threads

R
RCA output question
https://www.amazon.com/dp/B0CJB5TTPB/?tag=caraudiocom-20
8
229
Amplifiers
AnthonyO
AnthonyO
Alex prior
RCA cable confusion
No make or model number on it? Do you have an exact picture of the rear and all its glory?
8
921
Wiring, Electrical & Installation
Doxquzme
Doxquzme
A
RCA VS HIGH LEVEL INPUT
Use two sets of RCAs. One set for the Front channels and the other for Sub Output and into Rear Input on the amp. Turn off the Rear Filter on the...
5
980
Amplifiers
1aespinoza
1
A
Using high level and low level(rca) at the same time
Thanks a ton for your suggestion to my rather long query, I ll follow it and see how it works out. Thanks again
2
816
General Car Audio
Aryan
A
H
Rca configuration
He'll be fine with any 4 ohm speakers, tuned properly. The focals are rated for 100 watts nominal and with the passive crossovers and power to...
6
881
General Car Audio
Doxquzme
Doxquzme

About this thread

C

corollabass

Member
Thread starter
corollabass
Joined
Location
Aurora,CO
Start date
Participants
Who Replied
Replies
2
Views
1,396
Last reply date
Last reply from
n2audio
Share thread
IMG_0005 (5) - Copy - Copy.JPG

Dan Medina

    Jun 17, 2024
  • 0
  • 0
Screenshot 2024-05-31 182935.png

Doxquzme

    Jun 15, 2024
  • 0
  • 0

New threads

Top
Menu
Home
Refresh