hifonics maxximus vs incriminator audio 40.1

Then you should know that there is no contest between 1 maxximus and 1 40.1
Moron.
like i said i am not new to car audio....forums say nothing about what you can do with a system.if you look back a few pages you will see that it has now been clarified a long few pages ago that we are talking about 2 40.1s vs 1 maxximus(which is 2 goliaths)we are saying 2 40.1s because maxximus is 2 amps also

MORON B****

 
like i said i am not new to car audio....forums say nothing about what you can do with a system.if you look back a few pages you will see that it has now been clarified a long few pages ago that we are talking about 2 40.1s vs 1 maxximus(which is 2 goliaths)we are saying 2 40.1s because maxximus is 2 amps also
MORON B****
if its about price get the 40.1 if not then get 2 sampsons! if you were buying gear back then these prices arent that bad lol i can recall a 150x2 ppi amp costing 690 on deal

 
Actually i may have been into soundstream and orion however...in 91 i was in college and power 1000's had been around for a while by then so i dont know i do know in 84 i was on some audio while most were still in diapers.Hell i was a pup to some guys myself back then.Just the point is try to respect another and maybe they might try to respect you.

 
The review was done by Performance Auto Sound Magazine.You mean the one that had the green Pontiac on the cover???The solstice show car??? That PAS magazine???

On page 122 of said magazine it says "although designed for SPL applications Signal linearity is still Very important. linearity was measured at 4 ohms stereo and output was depicted as remaing linear for 79% of its total wattage range,about 8,316 watts...Pretty Nice now...

At 14.6 Volts they got 5.289 and 5,288 at 1 ohm stereo@50 hertz (damping factor of 280 and 279 per side)

and at 2 ohms bridged 10,526 @50 hertz but this was at 14.4 volts (no available damping factor)

now the thing didnt Clip until 12,209 watts!!! Impressive...

Now that was at 14.4 and 14.6 respectively my question is this???What type of power supply sections are they running?Are they regulated or unregulated???

Im curious as to what is going on with them because i cant seem to find this info...and Hifonics has said the amplifier will supply optimum power into either a 2 ohm mono load or a 1 ohm stereo load.With other configurations yielding LESS...It is said that maximum performance will be achieved at 1 ohm stereo or 2 ohm mono loads.

now im looking at your post and i see all these other voltage ratings and power outputs...where can i see those at?Because officially we have 12 and some change on a clip @ 50 hertz according to performance autosound magazine.
 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

About this thread

ghettoknock

10+ year member
Member
Thread starter
ghettoknock
Joined
Location
lebanon
Start date
Participants
Who Replied
Replies
178
Views
13,694
Last reply date
Last reply from
OldSchoolBass-G
1781975538525.png

Doxquzme

    Jun 20, 2026
  • 0
  • 0
1781975510897.png

Doxquzme

    Jun 20, 2026
  • 0
  • 0

New threads

Top