fitting 4 15s in a ranger?

[R34P3R 10+ year member]

How the hell do you plan on getting it inside your truck?

 

[pro-rabbit 5,000+ posts]

build it inside the truck

 

[RangerDangerV2 5,000+ posts]

How the hell do you plan on getting it inside your truck?

build it inside the truck. and its a 4 door, so if I take the seats out it will be really easy.

 

[pro-rabbit 5,000+ posts]

got it...

Gross volume (with no front added to the design, but using internal dims up to the front lip) is 20.12 ft^3

 

[RangerDangerV2 5,000+ posts]

got it...
Gross volume (with no front added to the design, but using internal dims up to the front lip) is 20.12 ft^3

that was fast! where should I send monies to? and with a rough estimate of displacements do you think that I can fit 4 15s??

 

---------- Post added at 11:45 AM ---------- Previous post was at 11:44 AM ----------

 

oh and there will be a double baffle so the front dim needs to be shortened by 1.5"....

 

[pro-rabbit 5,000+ posts]

Ok, if the double baffle front shortens the enclose give me a sec and I will get you a new gross volume.

 

[pro-rabbit 5,000+ posts]

18.47ft^3 gross with a double baffle

 

[RangerDangerV2 5,000+ posts]

18.47ft^3 gross with a double baffle

did you use torres?? because thats exactly what I got... only I didnt subtract the hump in the back and the angled sides on the top.... and does this include wood displacement?

 

[RangerDangerV2 5,000+ posts]

@pro\-rabbit ;

 

[pro-rabbit 5,000+ posts]

did you use torres?? because thats exactly what I got... only I didnt subtract the hump in the back and the angled sides on the top.... and does this include wood displacement?

I used basic match based off your dims in the sketch up design. That is after all wood displacements though. That is exact gross volume per your design after all wood. Bracing, port, and subs are not accounted for in that volume.

 

[RangerDangerV2 5,000+ posts]

ok so 18.47 after the hump in the back and what not... whats your paypal address? I may just have you do a design for me...

 

[pro-rabbit 5,000+ posts]

Paypal is Orders@DC-Creations.com

I can work something out if you like. Just let me know what subs you are good to go with and we can work out port area, tuning and see what you have going on.

 

[pro-rabbit 5,000+ posts]

And yes, that is the volume after wood and the angled top and the notch in the back.

 

[bhsdriller 10+ year member]

you could fit it...teammate had 4 15" mayhems in his s10, a lot less room then what you have. His box was like 10cuft after displacements lol

Still did good numbers tho

 

[pro-rabbit 5,000+ posts]

you could fit it...teammate had 4 15" mayhems in his s10, a lot less room then what you have. His box was like 10cuft after displacements lolStill did good numbers tho

Just makes it peaky normally and a loss on low end. It also depends on port area and such...

Not sure why he only had 10ft3 though I had that below the window line.