Factory vs Aftermarket

  • 3
    Participant count
  • Participant list
The factory amp could've been more powerful. //content.invisioncic.com/y282845/emoticons/confused.gif.e820e0216602db4765798ac39d28caa9.gif That's my guess. Or you don't have the settings on the new amp right, I.E. gain, xovers, etc

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

Similar threads

You can run the SVC subs on the GM-DX871 at 1 Ohm, just lower the gain at the amp. The third sub is too different to run on the same amp as the...
1
970
@1aespinoza I see, so this audio volume leveling is what I was experiencing tapping into the Bose sub wires. Well then, I'm off to check out the...
4
1K
I own a 2016 Lincoln MKT. I purchased a FORScan chip to increase the power handling of my aftermarket speakers. However, I'm having trouble...
0
669
If you buy a replacement OEM Radio Harness the colors will match up then you can use a wiring harness to connect to that. According to a few...
1
551

About this thread

JusBlaze

10+ year member
CarAudio.com Elite
Thread starter
JusBlaze
Joined
Location
SouthSide
Start date
Participants
Who Replied
Replies
4
Views
565
Last reply date
Last reply from
JusBlaze
20240518_170822.jpg

Dylan27

    May 18, 2024
  • 0
  • 0
20240517_190901.jpg

Dylan27

    May 18, 2024
  • 0
  • 0

New threads

Top