Buying front stage.

IshbOO
10+ year member

Senior VIP Member
Im looking into buying frontstage system within the next few weeks. My speakers are blown and needa replace them asap. I'm wanting a component system 6.5 and i think the mounting depth needs to be below 3 inches. I will install a 3/4 mdf ring as well. I have an amp also.

I got somewhere around 100-200$ to spend

Anyone have any suggestions?

I have been looking at Orion P6.2 system, Anyone have any info on these? I know thye make good amps and subs, How are their comps?

Also the Crystal sscs6 but ive heard fellow integra owners have ran into problems mounting them.

 
I want a comp system. And I will be running off the headunit for a month or so. The amp I have will be running 100-150 rms at 4 ohms. And the orions are 3ohm VC.

I want strong midbass, and some loud tweeters. I have never heard titanium tweeters but willing to give them a shot.

 
The P6.2 are excellent, if you can still find them... I think they have been discontinued.

Better yet would be Cerwin Vega V-Max 65... do a search on Froogle.com

The Crystal SSCS is bigger than a standard 6.5"... I know the hole cut-out is 5.75"... I believe the mounting ring/outside diameter is bigger also... not sure of the exact measurement... probably closer to 7"

 
Orion HP2800 ?

Max Power 600

4 Ohm Rating 125 x 2

2 Ohm Rating 200 x 2

1 Ohm Rating -

Mono Rating 600 x 1

Freq. Resp. 20 - 20khz

THD+N

Damping factor > 200

Signal to noise ratio > 77

Crossover range/scope LP 20 - 3khz

HP 20 - 3khz

Input sensitivity 200mV - 5V

Safe load impedance 2 ohm stereo

Equalization Circuit Intelli Q

10 db

Remote level control N/A

Amplifier protection* T,D,R,S

Externally Bridgeable No

Dimensions** 12.6” x 10.2” x 2.4”

*T - Thermal protection, D - DC offset protection, R - Reverse polarity protection, S - Short circuit protection, O - Over/under voltage protection

* All power ratings are @ 13.8VDC supply Voltage, all channels driven

** Amplifier dimensions are for heat sink only; add 2 1/2 inches per side to allow for end cap installation

Good for crystals? 4 ohms right?

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

About this thread

IshbOO

10+ year member
Senior VIP Member
Thread starter
IshbOO
Joined
Location
St.Louis, MO
Start date
Participants
Who Replied
Replies
13
Views
828
Last reply date
Last reply from
IshbOO
IMG_0710.png

michigan born

    May 14, 2026
  • 0
  • 0
IMG_0709.png

michigan born

    May 14, 2026
  • 0
  • 0

New threads

Top