Reply to thread

Message

<blockquote data-quote="IshbOO" data-source="post: 2729776" data-attributes="member: 556188">Orion HP2800&nbsp; ?Max Power 6004 Ohm Rating 125 x 22 Ohm Rating 200 x 21 Ohm Rating -Mono Rating 600 x 1Freq. Resp. 20 - 20khzTHD+NDamping factor &amp;gt; 200Signal to noise ratio &amp;gt; 77Crossover range/scope LP 20 - 3khzHP 20 - 3khzInput sensitivity 200mV - 5VSafe load impedance 2 ohm stereoEqualization Circuit Intelli Q10 dbRemote level control N/AAmplifier protection* T,D,R,SExternally Bridgeable NoDimensions** 12.6” x 10.2” x 2.4”*T - Thermal protection, D - DC offset protection, R - Reverse polarity protection, S - Short circuit protection, O - Over/under voltage protection* All power ratings are @ 13.8VDC supply Voltage, all channels driven** Amplifier dimensions are for heat sink only; add 2 1/2 inches per side to allow for end cap installationGood for crystals? 4 ohms right?</blockquote>

[QUOTE="IshbOO, post: 2729776, member: 556188"] Orion HP2800 ? Max Power 600 4 Ohm Rating 125 x 2 2 Ohm Rating 200 x 2 1 Ohm Rating - Mono Rating 600 x 1 Freq. Resp. 20 - 20khz THD+N Damping factor > 200 Signal to noise ratio > 77 Crossover range/scope LP 20 - 3khz HP 20 - 3khz Input sensitivity 200mV - 5V Safe load impedance 2 ohm stereo Equalization Circuit Intelli Q 10 db Remote level control N/A Amplifier protection* T,D,R,S Externally Bridgeable No Dimensions** 12.6” x 10.2” x 2.4” *T - Thermal protection, D - DC offset protection, R - Reverse polarity protection, S - Short circuit protection, O - Over/under voltage protection * All power ratings are @ 13.8VDC supply Voltage, all channels driven ** Amplifier dimensions are for heat sink only; add 2 1/2 inches per side to allow for end cap installation Good for crystals? 4 ohms right? [/QUOTE]

Verification