system installed but one sub is not working.

[99grandprixGT 5,000+ posts]

i just finished hooking my 2 DVC 2 ohm CVR's. i have them hooked up to a kenwood KAC-9103D.

so the amp is getting power, one sub is working, the other is not. the one is not getting any power at all. i checked the wiring again, and its the same as the other one. i tryed testing the amp with a DMM but i dont get a reading. what setting should i have it in? anything i can check to see whats wrong? thanks alot.

also, which one if these is the gain? the bass boost, the input sensitivity, im pretty sure its not the the low pass filter. thanks in advanced.

AMP:http://www.crutchfield.com/S-we740TDwBN1/App/Product/Item/Main.aspx?I=113KAC9103

Click to read more...

 

[ultimate157 5,000+ posts]

i just finished hooking my 2 DVC 2 ohm CVR's. i have them hooked up to a kenwood KAC-9103D. so the amp is getting power, one sub is working, the other is not. the one is not getting any power at all. i checked the wiring again, and its the same as the other one. i tryed testing the amp with a DMM but i dont get a reading. what setting should i have it in? anything i can check to see whats wrong? thanks alot.

also, which one if these is the gain? the bass boost, the input sensitivity, im pretty sure its not the the low pass filter. thanks in advanced.

AMP:http://www.crutchfield.com/S-we740TDwBN1/App/Product/Item/Main.aspx?I=113KAC9103

Gain is the input sensitivity.

Check the voice coils on the sub for resistance (Ohms). Make sure they aren't dead.

 

[99grandprixGT 5,000+ posts]

ends up the wire was broken off at the VC so i returned it for a new one.

i still need help with tuning the amp though i have a thread here if you could help thanks

http://www.caraudio.com/forum/showthread.php?t=273115