Do you think that’s enough airspace for those 10’s? Website recommends 1.5-1.75 per sub but as discussed, not sure how accurate their specs are.
I selected around all 4 subs, copied, then pasted back into the picture then moved them up, distorted the angle slightly, erased some stuff and BAM!!
1.1 cubes is tight. I looked at the SA10's and they only call for one cube ported per sub. My box builder says that the 10's will work in the box that I already have. 1,200 ounces of motor force and a 5K amp seem like a lot for a ¾" MDF box. The subs alone weigh 185 pounds.
I was going ask if he could go taller above the window lineNew box... maybe 6" taller?
Maybe. I will post it tomorrow if I can. I am getting sleepy..... Wow... I'm quoting myself. Anyway here is the pic I promised myself lolInteresting. Can you separate the two sets of 4 further to each side to make a gap in the middle?
I guess you could try it and then build a new box if you’re not satisfied. I like the SA idea since they require a smaller box.
Maybe. I will post it tomorrow if I can. I am getting sleepy.
That would most deff damage a windshield. Even the 4 extra 8s would get down on some powerit's sloppy but it slams!!
I was going ask if he could go taller above the window line
do a blow through already...
That would most deff damage a windshield. Even the 4 extra 8s would get down on some power