Sub is not working properly. please Help

[backtofront001 10+ year member]

I just wired my sub and amp to my car. RL-P wired at 1 ohm to an Orion 600D. The sub diesnt get loud at all. The only way i know it is on is by touching it or getting really close to it. I used PAC Trunk-LOC to wire everything because I used factory HU. Can someone tell me what is going on?

Click to read more...

 

[mmata13 10+ year member]

check ur gains(and all other settings on ur amp) balence fade and bass on ur radio. volume on ur(loc thing) if it has any. if that dont work go buy a read h/u

 

[xploit2 10+ year member]

yaah I would check the GAINS setting.

 

[backtofront001 10+ year member]

Just did the multimeter test to adjust gain but I am getting 0 volts on the multimeter. But sub is moving very little when not as much as it should when music is on. What is going on?????? Someone with a soul please help me. I ve been at this for very long and now I dont know what to do

 

[xploit2 10+ year member]

you moved the gain counterclockwise and nothing happend?? like mmata13 said balence fade and bass on ur radio. volume on ur(loc thing) if it has any

 

[backtofront001 10+ year member]

Yea, I did all that and the sub was which is getting 600 watts RL-P sounded like my JL W0 getting barely 100 watts. Not loud enough. SO, i said let me try with a multimeter and do the gain tutorial on this website and I am getting 0-0.2 volts ish on the multimeter. What is wrong????

 

[backtofront001 10+ year member]

I apologise. I did the multimeter thing again and I get total of 8 volts with the gain turned all the way up. I am supposed to be looking for 24.50 so something is definately wrong but I dont know what to do //content.invisioncic.com/y282845/emoticons/mad.gif.c18f003ab0ef8a0d9c27ca78d77a6392.gif