Speaker terminals not putting out

[Another Device 10+ year member]

I just installed my ed 9.1 friday night. It worked fine, I set the gain using the method stickied in this forum. While I was driving around Saturday with it pushing my sub(man did it ever pound), it just cut out. All the fuses are intact, and it still turns on. I tested the rca's on another amp, they work fine. Tested the subs VCs, Dual 2 ohm, both read 2.3-2.5. Tested the speaker terminals, and I didn't get any voltage reading. Did I mess up somehow setting it up? Or did I just get a bad amp. I'm going to call ED on Monday and see what they think.

Click to read more...

 

[Prowler573 5,000+ posts]

Check the RCAs and see if the amp is getting any input?

 

[_DjScrew_ 5,000+ posts]

Check the RCAs and see if the amp is getting any input?

I tested the rca's on another amp, they work fine.

but, try bypassing the speaker terminal and see what happens

 

[azngotskills 10+ year member]

Same kinda thing was happening to me today. Did you happen to check all you wiring, ESPECIALLY the ground. Thats what my problem was, also a blown fuse.

 

[Another Device 10+ year member]

Well, it seems the amp is getting power according to the green light on the back, so i don't think its that.