Scion tc daily driver to show worthy project

Finally managed to neaten up the wires and run the power wire to the alternator.

98572_18328cf694.jpg


98573_43a82c4ff9.jpg


98571_7c4c18d278.jpg


I need to get anchors for the front wires. Doctor has me on glucosamine so my hands are not hurting as much.

New measurements with the power cable to the alternator replaced:

Test Before. After. Today

Battery. 12.38. 12.69. 13.72

Alternator. 13.61. 13.44. .......

Dist block. 13.18. 13.20 13.38

 
Got the mid ranges in finally

Cut inserts from polypropelene plastic(?)

98635_6bc9b06f4f_m.jpg


Then mounted mids

98639_4cb8254e61.jpg


Got both ready for install

98637_053450c9da.jpg


and installed them in the heat ducts. (dont drive it in cold weather)

98638_3a1558a2fb.jpg


I will take the factory vent trim ring and wrap it in black speaker cloth.

 
you arent worried about the flimsyness of the plastic the mid is mounted in... faily large amounts of energy @400hz...just wondering //content.invisioncic.com/y282845/emoticons/smile.gif.1ebc41e1811405b213edfc4622c41e27.gif

 
It is mounted from behind it isVERY secure. But I do thank you for the concern, and it is a valid concern based on what you see.

 

---------- Post added at 12:31 PM ---------- Previous post was at 12:31 PM ----------

 

I also bench tested the mid's far harder than I will play them at for vibration .

 
Got the drivers side door on with rivets, need to paint them black next.

98664_8539e95963_m.jpg


I used long neck rivets

98665_d37f5c8f78_m.jpg


Even without sound processing, just using the amp, the 3 ways sound AMAZING!!!!!

 
nice work. I see your using a circuit breaker.. if thats for your audio power i would advise against it, they dont break contact fast enough in such applications

 
It's not for protection, the stereo is fused another place. it is for quick disconnect so the dealership doesn't accidentally start it with volume on or mess with it.

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

Similar threads

NADBL is the org that we get up here in the northeast, they do some shows in Ohio and upstate NY and into Canada, might be close-ish to you...
36
4K
If you wire it to 1 ohm it will make 15,000W You should expect to pay at least double the MSRP of that amp in electrical upgrades to properly...
1
1K
Just playing around. He's not even turning it up...
37
5K
Technically I need to have the internal Regulator replaced, but considering it's cheaper to buy an ECU for 350-400, send it to get the immobilizer...
137
19K

About this thread

excelon72

10+ year member
Member
Thread starter
excelon72
Joined
Location
lafayette,nj
Start date
Participants
Who Replied
Replies
41
Views
8,901
Last reply date
Last reply from
excelon72
Screenshot 2024-05-31 182935.png

Doxquzme

    Jun 15, 2024
  • 0
  • 0
Screenshot 2024-05-31 182324.png

Doxquzme

    Jun 15, 2024
  • 0
  • 0

New threads

Top