Port Length

Cameron
10+ year member

Member
I am in the process of designing a box for 4 re 8's. My dimensions for my trunk are 35 in width

10 in depth

10 in height

if my calculations are correct that should be just about 2 cu ft. I want to port the box but i am unsure how long and how big the opening is supposed to be for 35 hz.

Anyone know how to find this?

thanks

 
Is this accurate because i have tried on winisd and bcae1 too. Also do u know if 35in is big enough for 4 8's and a 3 in port. On paper it is exact but will that work?

 
I got 43.97 in for the minimum area

6.63 for the length of side for a squre vent

then i put that i wanted a slot port with 5in height and a 3in width and it said 11.8 inches.

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

Similar threads

I'd have the internal port end 7" away from the back wall and just roundover that corner. That back (rounded) wall should effectively extend the...
3
2K
Yeah, saw that too, was like ??? wtf! They do know there stuff, I usually just roll with it!
13
1K
You could try to make the port longer, but there might be other reasons with the box won't extend lower, or even the sub. You'd have to reverse...
3
1K
While that program is pretty neat, it assumes you know the values. I was just recapping the numbers you provided. RS recommends the following...
4
1K

About this thread

Cameron

10+ year member
Member
Thread starter
Cameron
Joined
Location
Escondido, CA
Start date
Participants
Who Replied
Replies
7
Views
582
Last reply date
Last reply from
Cameron
20231205_074421.jpg

spokey9

    Jul 17, 2024
  • 0
  • 0
Screenshot_20240715-132222.png

1aespinoza

    Jul 15, 2024
  • 0
  • 0

New threads

Top