Passive x/o

[The Camry]

Thinking about how to run multiple speakers in a boat set up off a 2 channel. Essentially 4 6.5s and 4 tweets.

This would have to be done using passives and some interesting ohm loads. Stereo separation in an open air boat means nothing so a mono signsl would be just fine to all speakers. its late and I dont wanna think atm. How would you do this?

Click to read more...

 

[pickup1 5,000+ posts]

Use the passives,parallel them for a 2 ohm load. That is,if they are 4 ohm and the passive keeps it that way.

 

[trumpet 5,000+ posts]

Two 4 ohm component sets in parallel pairs? Why make it difficult?

 

[El-Camino]

Bridge the amp and run both mid and tweet in parallel pairs of components & then in series between the pairs, gives you a total of 4 ohms in mono. To clarify. If you had a front set & a rear set, you would wire the front together in parallel. Same for the rear, then series the front and rear together.