- Thread Starter
- #16
ok ive been messing with WinISD but im a n00b to it. Ummm real quick are these the right parameters to my L7's?
amartin_72
Banned
Well are those the paramaters from kickers website? For final reccomendations, make the box as big as possible, at least 6ft each, get at least 125 inches of port area, and when you think youve braced it enough, add twice as much bracing. Tune from 32-36hz. Use a 7/64th drill bit, and 1 5/8 screws. Keep the screws away from corners a little, to reduce the risk of splitting.
- Thread Starter
- #18
i apoligize but could someone please double check my parameters I put in? I do not know for sure if they are all right. Thanks A LOT!!
- Thread Starter
- #19
Please somebody? I would really like to get this box built today/tomorrow if you guys can help me out a little more
Activity
No one is currently typing a reply...
Similar threads
I am considering upgrading the sound system in my 2013 Ford F150. I have identified three potential head units: the Sony XAV-9500ES, the Pioneer...
- Started by Arizreynoldsxxxx
- Head Units
How I would approach it is install your new amplifier and start using it.
Install a voltage gauge and if you see your voltage lowering then add...
- Started by Ellessucs
- Wiring, Electrical & Installation
While most Asian and African markets will identify Honda's small hatchback as the Jazz model, most Western regions will know the same model as the...
- Started by mhdali1
- Wiring, Electrical & Installation
The Kappa's have a high sensitivity rating of 93 db so the X802-5 would be fine. A good high sensitivity 8" sub in a properly sized box would fit...
- Started by kanihoncho
- Amplifiers
Yup , the dsp should have input sections, it may have one for sub?
Hu to dsp. Dsp to amps, amps to speakers. Probably help you to draw this all...
- Started by supafly1
- General Car Audio
About this thread
New threads
-
-
-
-
Head unit 1 output rcas, to 5 channel amp, LOC or 1 set off HU
- Started by RyanJ0022
- Replies: 6
-