SaintlyDemonic
CarAudio.com Newbie
Hello all! Lets start with what is in this jeep that i have just purchased.
Head Unit: alpine cde-172bt Link Here
Amplifier: Kicker CX 1800W Class D Mono Link Here
Subs: KICKER - CompR Dual 12" Dual-Voice-Coil 2-Ohm Subwoofers Link Here
Now, everything WAS working. Everything listed above is less than a 8 months old. The only thing to change between it working and now is it had sat for about a month and the battery has been disconnected. Moving on, this is what I have checked and how!
Head Unit > Ive checked the settings related to bass to make sure theyre on(at least I think I checked them all) Im more assumign bc this is almost a new unit...
RCA Cables > I hooked them up to a pc speaker and touched the other end with my finger and it gave output to the speaker.
Subs > I touched the speaker wire to a positive connection for a second to make sure the cone moved etc. they seem fine.
Amplifier> Now this is where stuff is funky, When everything is hooked up right and touch the RCA on the head unit side no feedback is given. The amp is ON and its Protection mode is OFF. I don't understand what has happened. Everything worked and now it doesn't. (It didnt stop working while on! I just started the jeep and boom no more subs) The inline fuse is ok and this amp doesn't have onboard fuses if im correct. i just dont know anymore... ANY suggestions or help would be awesome!
Head Unit: alpine cde-172bt Link Here
Amplifier: Kicker CX 1800W Class D Mono Link Here
Subs: KICKER - CompR Dual 12" Dual-Voice-Coil 2-Ohm Subwoofers Link Here
Now, everything WAS working. Everything listed above is less than a 8 months old. The only thing to change between it working and now is it had sat for about a month and the battery has been disconnected. Moving on, this is what I have checked and how!
Head Unit > Ive checked the settings related to bass to make sure theyre on(at least I think I checked them all) Im more assumign bc this is almost a new unit...
RCA Cables > I hooked them up to a pc speaker and touched the other end with my finger and it gave output to the speaker.
Subs > I touched the speaker wire to a positive connection for a second to make sure the cone moved etc. they seem fine.
Amplifier> Now this is where stuff is funky, When everything is hooked up right and touch the RCA on the head unit side no feedback is given. The amp is ON and its Protection mode is OFF. I don't understand what has happened. Everything worked and now it doesn't. (It didnt stop working while on! I just started the jeep and boom no more subs) The inline fuse is ok and this amp doesn't have onboard fuses if im correct. i just dont know anymore... ANY suggestions or help would be awesome!