newbie here...pic

[dvcevoblack 10+ year member]

New here & just showing my setup //content.invisioncic.com/y282845/emoticons/biggrin.gif.d71a5d36fcbab170f2364c9f2e3946cb.gif I did all this setup & builded myself.

I know caps **** by it just for show hehe

Back view yes it's messy but the seat is down

with seat up

Im gonna change the whole setup to ported box. Nobody hasnt answer my question yet which right here http://www.caraudio.com/forum/showthread.php?t=160459 //content.invisioncic.com/y282845/emoticons/crap.gif.7f4dd41e3e9b23fbd170a1ee6f65cecc.gif

Click to read more...

 

[Beat_Dominator 5,000+ posts]

Very nice //content.invisioncic.com/y282845/emoticons/thumbsup.gif.3287b36ca96645a13a43aff531f37f02.gif

 

[dvcevoblack 10+ year member]

thanks //content.invisioncic.com/y282845/emoticons/biggrin.gif.d71a5d36fcbab170f2364c9f2e3946cb.gif

 

[Ricky616 10+ year member]

nice lookin install the amp is //content.invisioncic.com/y282845/emoticons/yumyum.gif.0556df42231b304b9c995aefd13928a8.gif//content.invisioncic.com/y282845/emoticons/biggrin.gif.d71a5d36fcbab170f2364c9f2e3946cb.gif

 

[THUNDERBIRD 10+ year member]

nice install man

 

[bibby 5,000+ posts]

That be some clean work there man. GJ.

 

[dvcevoblack 10+ year member]

thanks guys

 

[ssj2xxgotenxx 10+ year member]

The cap isn't completly useless considering it tells you the voltage =). Thumbs up on the install, and do you have a secondary battery? I hope so because your fuse MUST be within 18 inches of your battery.

 

[AcidicDreams 10+ year member]

****... your're already a better installer than me, but the MTX boner is odd...

 

[dvcevoblack 10+ year member]

The cap isn't completly useless considering it tells you the voltage =). Thumbs up on the install, and do you have a secondary battery? I hope so because your fuse MUST be within 18 inches of your battery.

lol yea, i have 2 fuse actually. one is under the hood by the batt to cap then fuse to amp. just in case if cap blows up, then batt & amp would be safe. haha

it's like this: yellow top-wires-fuse-wires-cap-wires-fuse-wires-amp. im just precautious lol

 

[bigbangtheory 5,000+ posts]

Nice looking setup. I used to run 4 9500's in my cutlass off 2 of the 1501d's modded to 2000rms each. Needless to say it was stupid loud. Love the clean setup. Welcome as well.

 

[req 5,000+ posts]

nothing wrong with over fusing.

im not sure what size box the 9500 would like ported, i would look under manufacturer recomendations and then figure it out. id prolly tune it to the mid 30's tho. i would try ~3 cubes @ 35hz first and go from there. and you most likely are going to have to pay somone 5~10 to design you a ported box, its really not hard, but its not something i enjoy doing for kicks.