Need a new wiring kit

[Strangirs 10+ year member]

Hey guys,

I haven't done car audio in ages. I currently have a Skar RP-1500.1D and a Skar RP-75.4AB. I tried cheaping out and got an Installbay dual-amp kit which I regret. The person that installed it said that the wire is junk and that It's arching. Originally the fuse near the battery blew and I replaced it and it was fine for another month.. The four channel still works, just not the mono. I am wanting to look for a permanent fix for this on a budget. Looking at the amp ratings I feel like 4 gauge is too small, but that's what it fits. I currently have a distro running one gauge to four gauge.

I really want to get this fixed for under $100 preferably. I've been looking at OFC options below. Let me know if these will work or what better options there are!

SKAR4ANL-OFC | 4 Gauge - 1,500 Watt OFC Amplifier Wiring Kit | Skar Audio

Skar Audio designed the SKAR4ANL-OFC 4 Gauge, 99.99% Oxygen Free Copper, premium wiring kit to deliver unrivaled power and performance. Great for powering systems up to 1,500 watts, and will allow your amplifier to perform at its full potential.

www.skaraudio.com

http://www.knukonceptz.com/mobile-a...olossus-fleks-kable-10-red-power-ground-wire/ (get ~28 feet of this and use the distro block I have and fuse..)

Any ideas would help!

Click to read more...

 

[Popwarhomie 5,000+ posts]

So what exactly do you need? Just some wire to go from the D block to your mono amp? A fuse block as well? Or you are replacing everything?

Knukonceptz is my favorite as far as wire and rcas.

 

[Strangirs 10+ year member]

So what exactly do you need? Just some wire to go from the D block to your mono amp? A fuse block as well? Or you are replacing everything?

Knukonceptz is my favorite as far as wire and rcas.

Mainly looking to replace just the wire from the battery + d block. It seems that the wire is fine near the amps, but near the battery it's burnt up. (previous cheap kit fuse holder melted), which is now an ANL. I understand I'll likely have to replace the fuse again, but seems like Knukonceptz will do the trick.

Would four gauge be enough? Or should I opt for 0 gauge to 4 gauge distro.

 

[Popwarhomie 5,000+ posts]

I personally would do 1/0. You can get 15' of 1/0 welding cable for under $40 shipped from ebay which would be cheaper than KNU OFC 1/0.

 

[Strangirs 10+ year member]

I personally would do 1/0. You can get 15' of 1/0 welding cable for under $40 shipped from ebay which would be cheaper than KNU OFC 1/0.

Link would be great man! pm if necessary

 

[Popwarhomie 5,000+ posts]

Electronics, Cars, Fashion, Collectibles & More | eBay

Buy & sell electronics, cars, clothes, collectibles & more on eBay, the world's online marketplace. Top brands, low prices & free shipping on many items.

rover.ebay.com