need a box design...by this weekend

[Pyro_By_Nature 5,000+ posts]

It depends on the box for me.But personally I lay the bottom down, do the back, sides, front baffle, then port (if it attaches to the front baffle) and so on and I end with the top.

Just look at the design and you can get it.

 

[dvrmstrng 5,000+ posts]

but to do the back you gotta screw in through the bottom right?

 

[maldecido33 10+ year member]

i always do exactly what mountaineer man said; and you don't have to screw; i'd invest in some good clamps.

or, if you don't have clamps, do what i used to do. put the bottom board on a table with the back lip hanging over by a 3 inches or so. glue the back piece and set it where it's going. with the help of a friend/relative/whoever, screw it in. sit down and screw up, while your friend pushes down on the board and keeps it lined up. put a brick/weight on the front lip of the board, to help weight distribution.

 

[dvrmstrng 5,000+ posts]

well i started building but how high to i mount the port piece....at what inch mark...sorry stupid question but im stuck...let me know ASAP

 

[jeepintn 10+ year member]

the width of the port

 

[dvrmstrng 5,000+ posts]

so make the port as high as whatever the L x W comes out to be the square inches of port desired>

 

[jeepintn 10+ year member]

no, the "bottom" edge of the port in your design that i seen will be (W) high from the bottom of the box

 

[rpfuror 10+ year member]

how you build really depends on the design...

I did one similar HERE

BTW, I would have gave you a 3d build sheet if I designed it, typically by request