My first build in a long long time...........

  • 3
    Participant count
  • Participant list

jfreeman420
10+ year member

Junior Member
After much research and thanks to all the great posts on this forum, I have made a decision on some purchases. My system to be installed is as follows:

Soundstream VIR-6500 HU

Audiopipe 15001d (will be running at 1ohm)

Crunch GPV 1000.2 (2ohm for mids and highs)

Audiopipe 6.5 inch components front

Lanzar optipro coax rear

2- RF Power 10" 4ohm DVC (600Wrms ea.)

vented box 4

0 gauge wire all around.

I eventually plan to replace the 10" subs with 2 diamond audio 15" and have a custom built. The only reason I am using them now is I have had them for a while. Friend owed me money so I got these. I also plan to swap the crunch for a 4 channel and add a center channel to utilize the 5.1 surround sound on the HU, but these additions wont come for at least 3 or 4 months.

BTW, this is all going in a 2002 Toyota Sequoia limited.

Any feedback would be appreciated as I plan to place this order tomorrow. Anything I should swap out for the same or a bit more money that is better quality or am I on the right track?

I have been a car audio enthusiast since 1991 when I got my first car. My last system was all Orion components and it rocked. Sad to hear they aren"t on their game anymore. It's been about 11 or 12 years since my last install so all this new equipment is very exciting yet a bit intimidating.

 
Last edited by a moderator:
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

Similar threads

Well, I've owned probably over 100 different drivers in the last 40 years and almost every single speaker in the NVX line-up over the last 8...
16
1K
https://www.youtube.com/@therealmatty_s/videos
0
610
I think you're gonna have to get good with fiberglass or something, or find someone with a 3d laser scanner that can 3d print or mold you some...
7
1K
I got to message a DD woofer builder a decent bit my last stent of box designing; they would send me designs to do for or with individual...
5
971
Currently Audison amps 500.1 and 4.300 with kappa 90csx 6x9 component set. Pair of morel 6.5 rear and a single 10” alpine type R.
7
1K

About this thread

jfreeman420

10+ year member
Junior Member
Thread starter
jfreeman420
Joined
Location
Fort Lauderdale, FL
Start date
Participants
Who Replied
Replies
3
Views
844
Last reply date
Last reply from
jfreeman420
all out.jpg

Popwarhomie

    Jun 2, 2024
  • 0
  • 0
all out.jpg

Popwarhomie

    Jun 2, 2024
  • 0
  • 0

New threads

Top