You are an absolute retard.juggernaut cones, parts from mmatts p3, and dreadnaut motor
The **** is LOUD, I just got everything hooked up so **** yall haters sayin its too big and ****
I don't know the exact numbers on everything since it was designed by my buddy Tim (slumpinhonda), and who cares what mmats requires, that is bare minimum also for reccomended if you read correctly it says (4.5 not recommended for spl setups) or something to that matter, so i think its fine.
and the amp puts out 1700w at 2 ohms, I KNOW it wont get that much, but it will be close, because newer models put out theyre rated power so fuk ya too //content.invisioncic.com/y282845/emoticons/biggrin.gif.d71a5d36fcbab170f2364c9f2e3946cb.gif and anyway, for competitions ill be running it @ .5 ohms, and eventually for daily when i get a better electrical system
ill be putting up some vids later on tonight!
x2fwiw, the 2608's are capable of producing rated power.
iirc jake ballard was getting 1700 a piece @ 12.8v W/ something around a 2.5 ohm reactive load. Thats real world power, not dummy loads on a test bench.
But no matter what hifonics does no one will ever be able to say anything good about a brutus amp without someone snickering.
suk a dik //content.invisioncic.com/y282845/emoticons/rolleyes.gif.c1fef805e9d1464d377451cd5bc18bfb.gifYou are an absolute retard.
Classy.suk a dik //content.invisioncic.com/y282845/emoticons/rolleyes.gif.c1fef805e9d1464d377451cd5bc18bfb.gif
point is he doesnt have a 2608fwiw, the 2608's are capable of producing rated power.
iirc jake ballard was getting 1700 a piece @ 12.8v W/ something around a 2.5 ohm reactive load. Thats real world power, not dummy loads on a test bench.
But no matter what hifonics does no one will ever be able to say anything good about a brutus amp without someone snickering.
thanks! //content.invisioncic.com/y282845/emoticons/biggrin.gif.d71a5d36fcbab170f2364c9f2e3946cb.gifNice setup. Can't wait to see videos.