If install battery, what else do I need?

[RainStryke 10+ year member]

Im running 2 awg wires 3000w max

 

[KINGDELL91 10+ year member]

Hum not much help how much is your sub getting from the amp???

 

[thegreatestpenn 5,000+ posts]

he said what kind of amp he has already. I bet he wouldn't even pop a 80A fuse on full blast

 

[RainStryke 10+ year member]

This is the specs on my amp...

http://www.audiobahn.com/Audiobahn06/pages/amps.html

A2300HCT

2OHM Mono

1200w RMS

1OHM Mono

2400w RMS

I will be running them in 2 OHM Mono, unless I can figure out how to run 1 OHM mono, but I can't find any 1 OHM Mono wiring configs... Only 2 OHM and .5OHM.

 

[KINGDELL91 10+ year member]

Yeah i just looked it up

sub:http://www.sonicelectronix.com/item_2420_Audiobahn+AWIS15P.html

amp!http://www.onlinecarstereo.com/CarAudio/ProductDetail.aspx?ProductID=13506

suppose to be over 2k but its Audiobahn sooooo?????? but I'm running a lil over 2k and i have a HC 2400 and I'm going to change my stock to a walmart deep cycle special...

 

[RainStryke 10+ year member]

So, I should just get a more powerful car battery under the hood?

 

[thegreatestpenn 5,000+ posts]

yessir

 

[RainStryke 10+ year member]

Optima yellow top would be the best?

 

[KINGDELL91 10+ year member]

IMO i would do the second batt. if you want to be cheap go to wally world and get the ever start Maxx 29 marine batt for 72 bucks...

Here is a site to show you how to wire subs... there are a few other. i will just lead you to the water up to you to drink http://www.the12volt.com/caraudio/woofer_configurations.asp?Q=&I=

 

[RainStryke 10+ year member]

Im still confused by the 2 connectors on 4 sides... Total of 8 wire connections on the 1 sub.

 

[KINGDELL91 10+ year member]

Im still confused by the 2 connectors on 4 sides... Total of 8 wire connections on the 1 sub.

That site tell about big three and everything u need to know. but the 4 connectors mean you have quad voice coils.

 

[thegreatestpenn 5,000+ posts]

audiobahn does that so as to make wiring easier. you only have to use one terminal per piece of wire. READ THE MANUAL FOR HELP before you destroy your sub. Qual coil subs sux on the wiring IMO

 

[RainStryke 10+ year member]

That site doesnt list wiring configs for Quad Voice Coils.

 

[RainStryke 10+ year member]

I did read the manual... It only gives me a config for 2OHM or .5OHM on the quad voice coil configs.

*EDIT*

It also has configs on the quad voice coil for 8OHM's 16OHM's and 32OHM's.

 

[KINGDELL91 10+ year member]

READ THE MANUAL FOR HELP before you destroy your sub. Qual coil subs sux on the wiring IMO

X2 on that one