IB Install Help?

Even though they have an FS of 39Hz, and I had a 25Hz 12db/oct subsonic filter, I measured this in my cabin:

12Hz_AccordTrunk.jpg


It was a calibrated measurement, that is actual SPL. Not a record or anything, but still quite loud for 12Hz on 10 year old TB subs.

WHY?!? We were trying to test for a low frequency phase difference between two microphones using our acquisition gear - for the purpose of looking for phase of low frequency noise in an HVAC system. I figured my car would be able to produce adequate SPL levels at 12Hz (problem frequency for the HVAC system). So I put one mic in the trunk and one in the cabin and measured them at the same time. One downside to this test is that I could hear my vented woofers moving in response to the pressure. Which got me to thinking: does high SPL at low frequencies pressurize the speaker cones in the front of the car, causing distortion? me thinks so...

One interesting piece of information is that the harmonics in the cabin had a much lower amplitude than they did in the trunk. I'm not quite sure why that was and want to do further testing...

With only 180W RMS per sub as a rating i dont actually get to, from a fully regulated pre-motel xant amp, the output is enough to induce pain while remaining clean and clear. Plenty loud enough for me.

 
we should all post up our calibrated measurements at 12Hz and see what we can do... //content.invisioncic.com/y282845/emoticons/smile.gif.1ebc41e1811405b213edfc4622c41e27.gif

I have a Phoenix Gold Cyclone sitting in my basement I could dust off and hook up...

probably 100W RMS of power, EQ'd for SQ, 10 year old subs, subsonic filter, and i wasn't really pushing them. the test wasn't for SPL but to test pressure measurements for phase response.

 
we should all post up our calibrated measurements at 12Hz and see what we can do... //content.invisioncic.com/y282845/emoticons/smile.gif.1ebc41e1811405b213edfc4622c41e27.gif
I have a Phoenix Gold Cyclone sitting in my basement I could dust off and hook up...

probably 100W RMS of power, EQ'd for SQ, 10 year old subs, subsonic filter, and i wasn't really pushing them. the test wasn't for SPL but to test pressure measurements for phase response.
I was thinking maybe 2/3 Fi X 15's off if a Big Bells?

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

About this thread

Bettr n' Revrse

5,000+ posts
I do what I want
Thread starter
Bettr n' Revrse
Joined
Location
Grand Junction, CO
Start date
Participants
Who Replied
Replies
36
Views
2,529
Last reply date
Last reply from
Bettr n' Revrse
1778578257023.png

Glen Rodgers

    May 12, 2026
  • 0
  • 0
Screenshot_20260511_212804_Amazon Shopping.jpg

Blackout67

    May 11, 2026
  • 0
  • 0

New threads

Top