HELP!! wiring noob

The subwoofer you linked is already wired to 2-ohms. It has one set of terminals - just connect them to the amp output - done. No diagrams needed. You do NOT need to re-wire those subs to 4-ohms. That sub can handle 600W RMS continuous power. (300 W RMS per sub) (Forget about the peak watts - this is a useless spec - pay attention to RMS watts)

You need an amplifier that is 2-ohm stable and will put out between 300W RMS and 600W RMS into a 2-ohm load. The amplifier you linked is overpowered (1200W RMS into 2-ohms) for that sub - it is 2-ohm stable and would work, but be very careful setting the gain.

This amp would work just fine if you are dead set on Kicker and Bestbuy--> Kicker CX Series CX600.1 1200W Class D Mono Amplifier with Adjustable KickEQ Bass Boost 12CX6001 - Best Buy

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

About this thread

bassinmytruck

Junior Member
Thread starter
bassinmytruck
Joined
Location
Wichita, KS
Start date
Participants
Who Replied
Replies
5
Views
1,528
Last reply date
Last reply from
Jepalan
IMG_20260516_193114554_HDR.jpg

sherbanater

    May 16, 2026
  • 0
  • 0
IMG_20260516_192955471_HDR.jpg

sherbanater

    May 16, 2026
  • 0
  • 0

New threads

Top