Help subs not pounding

[pro-rabbit 5,000+ posts]

So u think there is a problem I have a mono block with two terminals I had each sub wired in series goin to there own terminal and it sound deep and hit hard

I don't think there is an issue at all. I personally think you had the settings far to high and the shop turned them down.

Your amp may have two terminals, but it is actually only one. It has two for making wiring easier.

If you think the wiring is not right, then pull each sub and verify how it is wired. Then check the wiring from the box to the amp.

 

[Warmachine9210 10+ year member]

I required them to series parallel this mornin and then the shop tuned them so I'm guessin they playin it safe but I can't go over 35 on my head unit cuz that where they maxxed my tuning

 

[pro-rabbit 5,000+ posts]

What subs do you have and what coil config?

 

[Warmachine9210 10+ year member]

Alpine type r 1st gen and 2 ohm dvc

 

[pro-rabbit 5,000+ posts]

Alpine type r 1st gen and 2 ohm dvc

You are wiring to 2 ohm I would take it?

If so, then yes series each sub then parallel them to the amp.

 

[Warmachine9210 10+ year member]

I did that I have ran series parallel and still sound lower

 

[pro-rabbit 5,000+ posts]

Then it is likely settings that were altered to keep your setup safe from damage.

 

[Warmachine9210 10+ year member]

I'm gonna jus sell em or find someone that will trade me

 

[SoOfficialAudio 10+ year member]

I'm gonna jus sell em or find someone that will trade me

Why give up so easy? There's nothing wrong with the subs. It's in your electrical. So selling your subs won't fix that problem. Check out your amp settings. I'm sure that will do the trick.

 

[Warmachine9210 10+ year member]

See that the thing I'm new to this and idk if the amp to high or wat I have a crunch 2000 watt 2050.1 amp to those subs amp is set at 2.25 voltage and barely any gain like the shop left it and they don't bump what should I do

 

---------- Post added at 11:07 PM ---------- Previous post was at 11:07 PM ----------

 

It's the brand new amp by crunch powerone

 

[Bigmann6374 10+ year member]

I have owned this amp and made the same mistake man... THat amp puts out 500 watts at 2 ohms not 1000 like you would expect. To get anything out of it you have to wire to 1 ohm.

 

[Warmachine9210 10+ year member]

I jus traded them for two 12 inch fosgate punch hx2 and got them wired at 1 ohm

 

[Warmachine9210 10+ year member]

And I jus got a flip out screen and at a cold start the fan in the headunit makes a squealing noise but after a few mins it goes away is it doing this jus from being cold