Hertz Mafia
FEATHER RUFFLER
No it means u need a bigger amp
LosIsATool
5,000+ posts
CarAudio.com Veteran
Or a better install
BSchrowang
Budget Builder
What clipping indicator is it? I know my taramps one is super sensitive to clipping
youdoofus
Skibidi
from how it sounded based on all his previous posts, it sounded like he has his electrical all in order
its the ssa amp, right?
My CT clip light goes off well before any dirty signal is even close.
I have three spare knobs and they all do it.
I know where my amp actually clips. I have it marked on the knob for 30hz and 40hz
I have three spare knobs and they all do it.
I know where my amp actually clips. I have it marked on the knob for 30hz and 40hz
The Camry
Hey, I Try.
I have a Cerwin vega 1000.1 with a clipping indicator on it. I put a 0db signal to it and watched it with my oscope. The light and the scope were dead on to eachother.
What db signal are you setting gains too? What is your electrical look like. Its possible you simply dont have the amperage to supply 2k worth.
What db signal are you setting gains too? What is your electrical look like. Its possible you simply dont have the amperage to supply 2k worth.
Jeffdachef
5,000+ posts
Gunz That Turn on Nunz
it detects slight clips however a soft clip is fine for your equipment.
THATpurpleKUSH
5,000+ posts
Fuckyou
I would run 0 gauge instead of the 4 gauge from the fuse block to the amp, even if its a short run.
Activity
No one is currently typing a reply...
Similar threads
- Started by Jay's ranger
- Amplifiers 2
- Started by akuma4u
- General Car Audio 2
About this thread
