Advice please

  • 4
    Participant count
  • Participant list

edwad_

Junior Member
My subwoofer only turns on when my cars engine is running. I like to go to the drive ins and would like to have some bass during the movie but I don't want to have my car running and waste gas the whole time. Is there a way I can have my subwoofer on without starting my ignition for this specific situation?

 
Wire your remote turn on to a 12v source that is on when the ignition is in the ACC position. Just watch out to not run it like that for very long, or you will more than likely kill your battery

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

Similar threads

Yup , the dsp should have input sections, it may have one for sub? Hu to dsp. Dsp to amps, amps to speakers. Probably help you to draw this all...
2
366
It also lowers the amps efficiency and raises the current draw.
5
490
i have a 15 already for the lows ita a little over kill for a crew cab but I like it and I was hoping it would sound better and louder than my old...
7
638
I always leave approx 6" or so for that very reason, in case I decide to swapp an amp if needed,or wanting too.RCAs ect. I deff do the extra 6-8"...
9
771
Honestly, beyond what you need. It will do the trick for sure, but it is excessive. Not a bad thing, just more than you will ever need. No need...
1
433

About this thread

edwad_

Junior Member
Thread starter
edwad_
Joined
Location
California
Start date
Participants
Who Replied
Replies
3
Views
570
Last reply date
Last reply from
audiobaun
20240519_201349.jpg

Mr FaceCaser

    May 19, 2024
  • 0
  • 0
20240519_201344.jpg

Mr FaceCaser

    May 19, 2024
  • 0
  • 0

New threads

Top