97 Ranger exhause problem HELP

[kizzo 10+ year member]

So I bought a ranger the other day and i realized that the exhaust is a corroded. It leaks pretty bad, when i put my hand by it it feels like a blow dryer.

Heres what it looks like:

to the left is where the CAT and the tailpipe are and to the right is where the engine is.

I've never even touched an exhaust before but im guessing i only need to replace it from the left back (part with the CAT on it).

How much do to get that shiz done?

Click to read more...

 

[dman4486 5,000+ posts]

advance auto carries all the factory exhaust parts pre-bent and with all the hardware. you should be able to do the entire thing yourself and save on the labor

 

[dman4486 5,000+ posts]

you will also need to replace the pipe on the right and the flange gasket

 

[kizzo 10+ year member]

how much am i looking to spend here a couple hundred?

 

[dman4486 5,000+ posts]

how much am i looking to spend here a couple hundred?

if you replace the cat, yes...if just pipe then you can do the entire system for ~$100 or less and bolt on

 

[kizzo 10+ year member]

could you show me what parts i need? I live right by an advanced auto and my zip code is 60123.

 

[dman4486 5,000+ posts]

what motor?

 

[kizzo 10+ year member]

4 cyl 2.3l

 

[dman4486 5,000+ posts]

the front pipe should be one of these

http://www.partsamerica.com/ProductList.aspx?parttype=688&ptset=A&searchfor=Exhaust+Pipe

and the extension pipe should be one of these

http://www.partsamerica.com/ProductList.aspx?parttype=690&ptset=A&searchfor=Extension+Pipe

If you go to advance, tell the guy you want to see his exhaust diagram book, look up your truck and write down the numbers next to the pipes you need and the gaskets...then the guy behind the counter can plug them into the computer and get them ordered

 

[kizzo 10+ year member]

and those are all bolt on right no welds

 

[dman4486 5,000+ posts]

and those are all bolt on right no welds

you may need a clamp, but for the most part they are bolt on with the exact flanges you already see under the truck

 

[kizzo 10+ year member]

how can i even get those bolts off

 

[explorer2 10+ year member]

cut them

 

[dman4486 5,000+ posts]

how can i even get those bolts off

cut them

^^^^exactly

 

[kizzo 10+ year member]

what if i were to cut that section out. like a foot of pipe including the coupling and found a pipe at advanced that would slip over the 2 halves and then just clamped it. would that work?