10" Sub

  • 4
    Participant count
  • Participant list

dnosryd
10+ year member

Member
Hey everyone what's going on!!. I've gotten quite abit of help here but now I'm trying something a little different and was looking for a little help. I have an '01 Ford Expedition and I'm wanting to change from the 12" SI D2 Claw I have now to a 10" mounted in a Thunderform in the net pocket to free up space behind the third row seat. Instead of the MTX 10" that comes with it I want to put in the best SQ Sub money not really an issue I can buy for this application. What I need is any recommendations for something that will work in this particular enclosure run off of a Concept amp that puts out they say 800wx1 at 4ohm, so a SVC 4ohm or a DVC 2ohm if there is a 10" that will handle it. Also it looks like space is really tight and on the specs the enclosure is only 6" deep with internal volume @ .6 cubic feet.

Any help is much appreciated.

Dean

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

Similar threads

Getting a good voltage reading does not mean good power transfer. You could read 13.8v out of a 24 AWG wire. Recheck your amplifier's ground and...
2
285
That would be a function of the harness, not the HU, I think. Have you looked into a Maestro or iData interface? i would check with crutchfield...
12
587
thanks DB, that definitely helps swallowing a $300 price tag 😂 these would essentially be running midbass for me too
12
616

About this thread

dnosryd

10+ year member
Member
Thread starter
dnosryd
Joined
Location
paramount, ca
Start date
Participants
Who Replied
Replies
3
Views
286
Last reply date
Last reply from
flakko
24 civic.jpg

Popwarhomie

    Jun 12, 2024
  • 0
  • 0
Screenshot_20240611-211145.png

Blackout67

    Jun 11, 2024
  • 0
  • 0

New threads

Top