wasted ink's RE build

[rc10mike 10+ year member]

Where does one get those 90* clamps?

 

[wasted ink 10+ year member]

i get them at a local building supply place, but im sure lowes or hd would have them... you can find them online everywhere too.. check out nothern tool, harbor freight... not sure on the quality though

 

[miker 5,000+ posts]

Lowes has them..

 

[wasted ink 10+ year member]

***MOCKED UP***

port corner

 

[wasted ink 10+ year member]

equal port width, length 1, corner, and length 2:

 

[IDSkoT 5,000+ posts]

Good job, man. Looks nice.

I'm definitely stealing that idea for my next slot port box. (the inside angled walls)

 

[Pioneer~Saturn 5,000+ posts]

Lookin good, ink //content.invisioncic.com/y282845/emoticons/biggrin.gif.d71a5d36fcbab170f2364c9f2e3946cb.gif

 

[wasted ink 10+ year member]

thanks guys, glad you like it

 

[peas247 10+ year member]

yea lookin sweet, i had a MT 18 in 5.7 cubes @ 31 hz and it slapped pretty hard

 

[wasted ink 10+ year member]

nice, what did you run for power/electrical? this one is a little over 5 cubes after displacements, at 33hz.

 

[peas247 10+ year member]

i had it runnin off a viper 2500d, 180 amp ea alt, 2 runs of 1/0, ngt extreme 34/78 under the hood and a ngt extreme g31 in the rear, in the trunk of a mazda protege

 

[wasted ink 10+ year member]

nice, im going to see what this thing does to my stock alt... hopefully i wont need to upgrade...

 

[rumblebee2 10+ year member]

i like what you did with the corners of the box. only question. on the inside of the box why did you add a piece of wood in the corner on top of the 45 and on the bottom? sorry if confusing.

 

[wasted ink 10+ year member]

i know what you mean. to answer your question, its because of the way i had to clamp it. i used the 90* corner clamps (seen on the previous page) so i needed to get those on some how. then, i added the end pieces. the entire interior of this box will be coated with fiberglass, so small pieces like that do not matter.

 

[Mr. C 10+ year member]

Nice work so far. Should beat hard down the block when done.

Keep the pics coming.