Just installed a new system in my 2016 tundra
setup
headunit jvc z1000x
amplifier Sony xmgs4 70 watts x4
speakers
siilver flute 6 1/2
tweeters focal twu1.5
I am getting almost no mid range
I sound treated the doors inside the door skin and outside
I used foam gasket material to seal the speaker adapter to the door and also use gasket material to seal the speaker to the speaker adapter
I used nvx fringe speaker foam to seal the speaker to the door along with the foam to reduce the sound wave from the back of the speaker
I have set the amplifier gain using a multimeter to get the correct watt that the amplifier is rated for
I used all new speaker wire to the speakers, I am going to use a active setup
I have not installed my sub amp or subs in the truck yet.
I gave the eq in the jvc set to flat. I have played many types of music. Ran test tones. Put on some heavy bass songs.
nothing of any real midrange will play of any volume
I know I am getting frequency to the silver flutes. At a 80 hz test tone I get sound. But not muck cone movement
what should I try to get this to sound like it should
crossover on the amp is currently set to full range
setup
headunit jvc z1000x
amplifier Sony xmgs4 70 watts x4
speakers
siilver flute 6 1/2
tweeters focal twu1.5
I am getting almost no mid range
I sound treated the doors inside the door skin and outside
I used foam gasket material to seal the speaker adapter to the door and also use gasket material to seal the speaker to the speaker adapter
I used nvx fringe speaker foam to seal the speaker to the door along with the foam to reduce the sound wave from the back of the speaker
I have set the amplifier gain using a multimeter to get the correct watt that the amplifier is rated for
I used all new speaker wire to the speakers, I am going to use a active setup
I have not installed my sub amp or subs in the truck yet.
I gave the eq in the jvc set to flat. I have played many types of music. Ran test tones. Put on some heavy bass songs.
nothing of any real midrange will play of any volume
I know I am getting frequency to the silver flutes. At a 80 hz test tone I get sound. But not muck cone movement
what should I try to get this to sound like it should
crossover on the amp is currently set to full range