This is like a impossible set up? Can anyone help me?

[madeitog]

WOW good stuff, but is their wires already connected that i would have to cut or anything? like if theirs anything DO NOT's just tell me real quick. Because when i drill the hole and on the back of it you will be able to see where the + and - go right? on each one. and the terminals on the back of the Box will be no good correct? I wanna make sure i can stand on my feet before i take off n run u know?

 

[jco1385 5,000+ posts]

WOW good stuff, but is their wires already connected that i would have to cut or anything? like if theirs anything DO NOT's just tell me real quick. Because when i drill the hole and on the back of it you will be able to see where the + and - go right? on each one. and the terminals on the back of the Box will be no good correct? I wanna make sure i can stand on my feet before i take off n run u know?

Ok, I'm gonna dumb this way WAY down. No offense.

Pull the subs out of the box.

Drill a hole in the back of the box behind each sub large enough for a speaker wire.

Pull a speaker wire through the hole, leaving enough room inside the box to connect it to the sub and enough out side (behind) to go to your amp.

Use caulk/silicone to seal up the hole.

Reinstall each sub, and wire the + wire to the +(red) terminal and the - wire to the -(black) terminal on the sub.

Wire each speaker wire to a channel on your amp. + to + and - to -. You will do this for each sub (using both channels of your amp).

You now have your subs wired to your amp at 4 ohms per channel.

 

[madeitog]

Your good bro, im a person that needs a lot of details on things because i dont want to mess things up. So on each sub their + -. Right? Thats like common knowledge, So just wire them and then run it through the hole you drilled to the amp. If that's right then im good? But all im stuck on here is the regular set up as of now theirs the terminals or w.e you call them on the back of the box? Before i do anything theirs wires running to them correct? Do i leave them their or just cut them and wire them like that?

 

[jco1385 5,000+ posts]

Your good bro, im a person that needs a lot of details on things because i dont want to mess things up. So on each sub their + -. Right? Thats like common knowledge, So just wire them and then run it through the hole you drilled to the amp. If that's right then im good? But all im stuck on here is the regular set up as of now theirs the terminals or w.e you call them on the back of the box? Before i do anything theirs wires running to them correct? Do i leave them their or just cut them and wire them like that?

They're wired together in the box. You can either cut and use that wire (probably won't be long enough) or just use new wire. You can just unhook what's in there, pull it out and run your new wires.

Edit, on that note, you can wire one sub to the terminal, and just drill one hole. Wire from terminal to amp for one sub, and sub to amp on the other. You see what I'm saying? This is basic stuff bro.

 

[madeitog]

So basically just wire them like they wasn't even together to begin with?

 

[madeitog]

Thanks bro so much. Imma go get then **** done now In a way we went from no hope to SOME wish me luck and thanks again.

 

[jco1385 5,000+ posts]

So basically just wire them like they wasn't even together to begin with?

Exactly.