Strange thing with System

cappy72
10+ year member

CarAudio.com Elite
928
0
NY
I read about amps going into protect mode due to the low signal of the remote wire when you have a couple of components hooked up.

Well I am starting to think that this is true... today I got a new d5 1200.1 amp(cause I thought the other one was having technical problems) and I hooked it up, it was connected to my active crossover. Well my amp starting going into protect mode for some odd reason. so I started looking because I thought it was odd to have 2 amps going into protect mode.

I started adjusting the gains and boom protect again... hmmm

so I decided to disconnect the xover and ran the Rca's directly to the 2 amps. hmmm... now the subs are stronger than before>??? this is odd

any explanations?

 
my firebird did that all i did was use a relay for the remote and it took care of the issue. was funny my old pioneer turned everything on a ok but the short lived alpine couldnt lol

 
good link... thanks

did you throw a fuse between the remote inputs and the relay output? if so what size did you use? I am thinking about a 5 amp fuse but I dont know if that is too little

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

About this thread

cappy72

10+ year member
CarAudio.com Elite
Thread starter
cappy72
Joined
Location
NY
Start date
Participants
Who Replied
Replies
9
Views
437
Last reply date
Last reply from
audiolife
1778578257023.png

Glen Rodgers

    May 12, 2026
  • 0
  • 0
Screenshot_20260511_212804_Amazon Shopping.jpg

Blackout67

    May 11, 2026
  • 0
  • 0

New threads

Top