Well the wire was already cut to this length from previous use with connectors on it already. Stringing it in front posed a lot of slack near a hot exhaust manifold.
x2......
Gotcha. I was thinking that tape laying mat would be beter. It's what I did. I just hope I made enough holes. I basically put one every 1/2" around the perimeter and along the bottom and side. I tape laid the mat on the back side and am waiting for it to dry to do the same on reverse. The main support for the pod will be it being screwed to the door sheet metal, so I just need the fiberglass to hold to the panel wellenough to look good against it. Will this technique of riveting do that for me?
With only 50k miles and sitting under carport it should be clean. I did get quite a deal. Thats why I had to jump on it. It has a dent n the trunk lid and a few small dings on the driver side because he was having problems driving. Mechanically it is sooo solid though.
Don't understand why it has to be removable. This car will be rocked until its death and eventual salvage yard home. Even if it was a car I might sell down the road, I'd just throw some cheap jensen comps in and sell the bish that way. I don't like pods that just bolt to the panel. For one they protrude out further to get proper volume and they have an ugly seam.
LMAO! I would say no problem, but what is the point to putting pods on doors that may never be used.
